Starter Tools, Toolkits, Recommendations and Tools Suppliers
Discussing recommended tools for getting started - toolkits and suppliers of tools
Subforums
-
Watch Repair Tools Supplier Database (1007 visits to this link)
55 topics in this forum
-
- 1 reply
- 3.3k views
-
- 2 replies
- 2k views
-
- 0 replies
- 1.9k views
-
- 11 replies
- 8.8k views
-
- 7 replies
- 5.7k views
.thumb.jpg.334efff2e136a28a6a01353fd041979e.jpg)
-
Topics
-
-
Posts
-
By watchweasol · Posted
Hi cleaning any rubber usually takes the surface off it a bit. Try a little IPA OR NAPTHA. ( lighter fuel) -
If you look like your passport photo, you’re too ill to travel 😂 Tom -
By LittleWatchShop · Posted
I have pondered such a plan. The unfortunate aspect of my 3d printing is accuracy. Not so great. So if I print something that works, I am almost guaranteed that the dimensions are not what was drawn. My purpose, even if inaccurate, was just to get a feel for the fit. I will look in to these service providers, though. Bear in mind, however, that part of the joy (if not all of it) is solving this myself. Otherwise, I just go mow the lawn or split wood or some other mundane task. -
-
By rjenkinsgb · Posted
I hardly have any of myself in the last few decades, though I do have my old passports etc. (with gradually degrading image quality; especially the last barely recognisable one, done in the Post Office dedicated licence & passport booth). Left to right, 1986 (at 30), 1997, 2007, 2018. Once the hair went, I've not really changed. My profile image is from 2001.
-
