What is this and should I remove

[Boogi11]

Hi all. I am stripping a raketa for practice and was doing well until the you tube finished with a few bits left in situ . What are the and how does the centre shaft come out please ?

 

 

Sent from my iPhone using Tapatalk

[SKEXIS]

Hello - do you have a photo of the bits? I’m sure we will be able to identify them and can then advise! 

[Andyclient]

14 hours ago, Boogi11 said:

 

Hi all. I am stripping a raketa for practice and was doing well until the you tube finished with a few bits left in situ . What are the and how does the centre shaft come out please ?

 

 

Sent from my iPhone using Tapatalk

 

Im guessing it's the canon pinion that needs to be removed so you can then remove the centre wheel , but a picture would confirm this 

[Boogi11]

Im guessing it's the canon pinion that needs to be removed so you can then remove the centre wheel , but a picture would confirm this 

The wheel in the middle. Forgive my ignorance is fixed in place. Is it an interface fit. Can I just pull it out



Sent from my iPhone using Tapatalk

[jdm]

10 minutes ago, Boogi11 said:

The wheel in the middle. Forgive my ignorance is fixed in place. Is it an interface fit. Can I just pull it out

I suppose there is a way to lubricate without messing with it?

BTW, there  is section in this forum to introduce oneself before asking questions.

Edited October 13, 2017 by jdm

[Boogi11]

I suppose there is a way to lubricate without messing with it?
BTW, there  is section in this forum to introduce oneself before asking questions.

Hi thanks still exploring this stupid tap tap app. Will have a look around the forums . A video on line by a different poster shows this wheel being put back into place with a firm click ( 2 halves through main body . One either side ) I want to strip it beat and then rebuild it to see if it still works . I’ll do some more research on splitting it

The attached video at 3.35 shows reassembly of the part

Sent from my iPhone using Tapatalk

[jdm]

4 minutes ago, Boogi11 said:

A video on line by a different poster shows this wheel being put back into place with a firm click ( 2 halves through main body . One either side ) I want to strip it beat and then rebuild it to see if it still works . I’ll do some more research on splitting it

I don't doubt it can be split, the risk is that wheels won't be perfectly parallel after reassembly (assuming  they are now). And that will affect performances. 

Edited October 13, 2017 by jdm