Jump to content

Replaced battery on Omega Deville will not start


provlima

Recommended Posts

I have an Omega Quartz Deville  that I have not used for 10 years.  Thinking its battery is dead I replaced with a new one. No luck it still doesn't start.

I've tested the new battery and its good.  Any suggestions as to what might be the problem?  Thanks for your help

Link to comment
Share on other sites

6 minutes ago, provlima said:

I have an Omega Quartz Deville  that I have not used for 10 years.  Thinking its battery is dead I replaced with a new one. No luck it still doesn't start.

I've tested the new battery and its good.  Any suggestions as to what might be the problem?  Thanks for your help

Might sound daft and have no idea of your expertise but have you fit the correct battery, many deville models take a 346 or 341 battery, I have seen many times where a 315 has been put in and damaged the battery connections and the back pushed on and the battery pushed into the movement, this not only twists or bends the movement it can also bend the dial. If this has happened in the past either the mainplate could be bent or possibly just the hands could be touching the bent dial.

Is the battery insolator sat in correctly?

Really need the calibre number off the movement to advise further, or even better some pictures!!

 

Link to comment
Share on other sites

Thank you for your kind reply I have attached photos. I have also attached a spec sheet I found indicating the watch needed a 9937 reference regarding the battery.

The one I took out was a 315. It fit in well and was flush with the top of the movement.   I noticed the bar holding the battery in had a thin  film on it that appeared to look like a deteriorated powdery sponge like texture. Could this be an insulator to prevent the bar from touching the back of the watch.

Your help is appreciated

Jim

IMG_2142[1].jpg

IMG_2141[1].jpg

Omega DeVille 1377.pdf

Link to comment
Share on other sites

6 minutes ago, digginstony said:

Your opening thread concerns me. If the battery was left in for 10 years ? It may have leaked and damaged the movement.

Sent from my SM-G920F using Tapatalk
 

It looks pretty okay inside the movement though? But there are some debris around the edges. There could maybe have come in to the movement? 

 

Link to comment
Share on other sites

should the + side of the battery be showing when the battery is placed in its compartment.  The document says to make sure negative side is facing bridge. Is th retainer bar called a bridge?  Also should the pin be making contact with the side of the battery?

Thanks for your help

Link to comment
Share on other sites

should the + side of the battery be showing when the battery is placed in its compartment.  The document says to make sure negative side is facing bridge. Is th retainer bar called a bridge?  Also should the pin be making contact with the side of the battery?

Thanks for your help


Most modern movements have + facing you but if memory serves me right the ETA 959001 is opposite ie.. + down - facing you.

Sent from my SM-G920F using Tapatalk

Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • Hello good watch folk ,I  just fancied a light hearted discussion after my head was starting to spin over Epilame 😅. Specifically I'm meaning the sale of vintage watches, say nothing past the 1980s market. The stuff we see on ebay and other similar sites and found at carboots, curio shops etc. And are  we thinking its reaching a peak volume ?  Younger generations clearing out passed parents and grandparents possessions.  The younger folk are not as sentimental as the old fogies ( I'm now nearly at an age that i used to think was old fogie age ). When might it have started ?  i often wish i discovered the hobby much much sooner when selling your grandfathers pocket watch at a boot sale for a few quid was just a way to offload some tat. And when might it slow down. Thoughts anyone ?
    • Yes i did eventually realise that the oil will act as a barrier, I'm sure the discussion will continue. Ive had two oleophobic coffees ( added coconut ) and in the meantime i have this just delivered to take my mind off epilame for the time being. My favourite type of dial, its a beautiful looking watch traditional English made and it runs,  the ticktock is phenomenal,  i can hear it across my living room .  You wont believe how much it was. Thats interesting about synthetic oils , i thought the same, going from a 2 year service to 5 years is a big drop in income for service folk.  I expect some did well when they embraced the use of synthetic,  probably drawing in more customers than those that didn't use the new fangled substances , i bet fairly short lived though. The more frequent service makes more sense to me, not for just the service but for the regular check up inspections that might pick up impending faults. As far as epilame goes, wouldn't it be great to be able to fumigate the complete movement in a sealed jar of heated stearic acid, 🤔 now theres a thought 😅.
    • Imm going to close the discussion by attaching the photo of my super-titanium after several vicissitudes finally working. Purchased as not working I replaced the battery and for a stroke of luck I found its semi-new solar panel which, having verified its operation, seems to recharge the accumulator perfectly. I had taken this watch almost by bet, with 40 euros I brought it back to life. The initial half idea was to resell it to finance another purchase, but.. it's definitely a nice item. It would need to check the impermeability but it's a pleasure to see it on the wrist 😃
    • In fact the secret is to go gently and find the way without forcing, and the movement enters without problems
    • Yea a have given it a full service this movement is chinese 2813 whats the lift angle for this movement does anyone knows  and how  do a remove the default  of 52 degrees on my timegrapher?   Hi you said my lift angle is default how do a remove this from my timegrapher?
×
×
  • Create New...