-
Recently Browsing
- No registered users viewing this page.
-
Topics
-
-
Posts
-
I don't think I have damaged a pocket watch hairspring but I have messed up a few wrist watches for sure. Also I use a screwdriver - don't have a better tool for it. -
By LittleWatchShop · Posted
It is how I do it. Often scary, but so far I have not damaged one. Removing the balance from the cock and adjusting it on a bench block is truly safer. -
By Neverenoughwatches · Posted
This much gap will make the rollers and all run too eccentric. The pin , the passing notch and the safety roller all have strict tolerances to coincide with the fork slot, gaurd pin and horns. Will it run ? Maybe, but it will restrict the escapement efficiency. -
-
By nickelsilver · Posted
Echoing Neven, the safety action on nice pieces is often very close, and a slight eccentricity can affect this. Runs great horizontal, then one or two verticals crap out. Without fail the balance will be above the escapement in these faulty positions- though sometimes also at horizontal to it, the "draw" (what pulls the fork to the banking) is often less than ideal, especially in older pieces and in my experience more with higher grade stuff. Suddenly the guard pin is rubbing.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.