Jump to content

Hello from Vienna


geebee82

Recommended Posts

A quick Hello from Vienna!

 

I am Georg, 41 years old and by profession a recording engineer, who recently found the new hobby of repairing mechanical watches, mainly old Seikos.

I am still very green behind my ears and have still a lot to learn, especially how much or rather little force to use if something needs to be pushed on...

But so fahr, I already got a few dead watches revived, and I am very much looking forward to expand my knowledge and dive deeper into the world of horology.

 

Cheers


Georg

Link to comment
Share on other sites

Thank you for your introduction and welcome to this friendly forum.

We all look forward to your contributions and continued involvement. 

Oh Georg how lucky you are. Austria is my favorite country. I fell in love with it way back in the 70’s. I have been to  Vienna and had a wonderful time. The Salzkammergut is the part I have had holidays in St Wolfgang is the place I stayed at.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • These are the places where I oiled with HP 1300...  These are the places where I oiled with HP 1300...  I can see that the cannon pinion is moving as it should once I installed the pallet fork. I created a small video but was not able to upload it. It is a mov file type. I need now to source a GR4014X mainspring, a stop ever #9433 and both calendar disc as the days/dates are peeling out... This is the mido watch which holds the ETA Movement.... I just want to thanks all of you guys for your help, specially @eccentric59 who nailed it! So, I would consider this case as closed unless of course any question from any of you... Best regards Fernando     I could not download the file... I will tray to located. Many thanks. 
    • Thanks a lot everyone!  I'll update you as soon as a final decision has been made by my friend (and depending on her decision, what I may find inside). 
    • Thanks Marc, clearly I have a lot to learn about metallurgy. I’d expect the cutting of tool or spring steel to be a lot harder to cut into a precise shape- I expect I’d have to anneal it first? 
    • Unfortunately if you have used mild steel you will have little hope of hardening and tempering it, it simply doesn't contain enough carbon. You need to use a steel with a higher carbon content like tool steel or spring steel. One good source for this is engineers feeler gauges which can be picked up relatively inexpensively and provide a range of thicknesses of material. this will then harden and temper in pretty much the way you have described.
    • Thanks for this excellent tutorial and very fine illustrations @Jon! Really first class! 👍 I noticed that your image was a bit too small to read with ease, so here's a larger copy of it. I summarized @nickelsilver's method for adjusting beat errors to the following, but you can find all the info in the thread I linked to: “For everyday work, from the smallest ladies’ movements to marine chronometer, I set the balance with the cock on a bench block so the roller table is in a hole, balance on the block. Lift up the cock and move it over- not flipping it, just moving laterally, until I can see the slot in the hairspring collet, get in there and adjust (for tiny watches this is usually with an oiler, larger, a small screwdriver). Go back in the watch and check on the machine. I hold a balance arm of the rim with tweezers while moving the collet.”    
×
×
  • Create New...