Jump to content

How to paint indices myself (not restoration, but daily beater)


Recommended Posts

Hi all, 

I've assembled various Seiko models in the past year and am thinking of modding Casio G-shocks square or round models next. 

In particular, I've come across a 'CasiOak' model online that has the indices painted and I would like to do that for myself. What kind of paint would you use in such case? Thinking of another hobby (model building) I'm thinking model paint like Revell is suitable - they have bold colours and, once diluted, can be applied with a very even finish. But perhaps it wouldn't stand a beating? I'd like to wear it as a daily beater. Of course, repairing it myself is not a fuss then :-)

Thanks!

Link to comment
Share on other sites

if the indices are inside the watch (below the crystal) model paints will be fine. I usually use womens nail varnish but thats a bit tricky .. best done in one go.. if you have to add a 2nd go wait until it dries.

After painting (with any paint) leave it to dry completely before installing, at least 24 hours. This is because the fumes may cloud the crystal and may also affect the dial paint.

Anil

Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • One-dip or naphtha should be safe, but are you sure it isn't magnetized?  I would also check that.  Although, if that balance is from an Elgin 760 0r 761, I would think it would have a hairspring of non-magnetic alloy.
    • Hi, Is there a spell check function available when you are posting ? Regards CJ
    • Hi John I just did a Seiko Lord-Matic a front loader without a split stem, I used a crystal lift to remove it, although I had to have it that tight I though I was going to break the lift before the crystal would budge. So I decided that the press would be a better option as I think crystals with tension rings resist a lot of compressing. I used a crystal press to repalce it and the bezel with no issues, obviuosly a different watch to the Omega. I just took my time and kept inspecting the installation progress bit by bit Regards CJ
    • Hello All, I’m replacing the crystal in an Omega Dynamic, # 165.039, which houses a cal 552, installed through the front of the case. The replacement Sterncreuz crystal is, like the original, with tension ring. I removed the crystal using a compressed air technique to pop it out.  (I have a crystal lift, but I’m always fearful of marking the crystal edges and so avoid using it as much as possible). Now to the replacement -  any tips on putting the crystal back in?  Am I obliged to using my dreaded crystal lift to complete the task, or how about a crystal press?  I’ve put lots of crystals in using a press, but never with the movement in the watch. The thought of using one with a front-loader makes me very nervous, with the fully assembled watch sitting under the press. How would more experienced folks proceed here? Any advice, gratefully received… John Down Under…
    • No thats straight out of the watch as i found it the balance wheel is almost as bad. I've never seen so much material removed.
×
×
  • Create New...