Jump to content

Question about PUW 1561 escape cap jewels

Lc130

By Lc130
in Watch Repairs Help & Advice

 Share

Recommended Posts

watchweasol Distinguished Member

watchweasol

Posted
Posted

Lubricate as normal, Innovations within the watch world like any other manufacturing industry take place because they either aid manufacturing or are easier to produce or produce a benifit to the watch or widget, It may have been experimental and produced on a short production line  for evaluation.

Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • clockboy
      L&R Varimatic Needs Adjustment

      By clockboy · Posted

      Welcome to the forum, enjoy. I have a varimatic that went  out of sequence because it’s hydronic oil ran very low. Must admit it’s still in my garage just know time to fix it. Purchased a cheap Indian Junta/ sonic Pearl as a stop gap a few years ago and it still performs perfectly so no incentive to fix the Varimatic. 
    • dnhb
      Is this a 'hack' ?

      By dnhb · Posted

      The plate is OK, thanks. It seems the answer to my question is that this is a 'hack' & for me another reminder that in general, one won't be the first person to be tinkering with an old timepiece!. As you day, I've been fortunate to have gotten some good advice and, just as important, encouragement. I've been lucky then not to have the balance spring break as a result of my novice 'ministrations' - but I did remember to 'stroke' rather than bend per se. The clock is of sentimental value to the owner so I'm relieved to have now got it running to time with the support & encourage of forum members like yourself.
    • storminwestie
      L&R Varimatic Needs Adjustment

      By storminwestie · Posted

      Recently purchased a L&R Varimatic knowing that the piston does not fully rise in the cylinder. The likely cause is air in the system. The manual calls for using a bleeder cup, which is as rare as hen's teeth.Does anyone have any experience with this issue and if so, how did they resolve it?
    • Neverenoughwatches
      Blew it with a coil

      By Neverenoughwatches · Posted

      Thanks ww, its maybe not as much of a bodge trick that i thought it was. 
    • oldhippy
      1st Post

      By oldhippy · Posted

      Thank you for your introduction and welcome to this friendly forum. We all look forward to your contributions and continued involvement.  It would be nice if you told us a little about yourself.
×
×
  • Create New...