Jump to content

I dropped my watch. What's the likely damage?


Tom23

Recommended Posts

Clumsy me knocked my beloved Seiko 5 off the desk onto a hard floor. I immediately stuck it on the timegrapher:

rate: -13; amplitude = 230-240; beat error: 1.0

Before the drop, I would get:

rate: -1; amplitude = 280-290; beat error: 0.2

It's a $100 watch, so not the end of the world, but still one of my favorites (and a good timekeeper to boot).

I'm guessing something in the escapement has been damaged, but I defer to the much more expert community here for the likely suspects.

Much Thanks.

Tom

 

Link to comment
Share on other sites

On 10/7/2019 at 1:51 PM, jdrichard said:

Perhaps a bend in one of the balance staff pivots

Sent from my GT-N5110 using Tapatalk
 

That would be easy to see on the timegrapher.  Would be impossible to get a straight line and think the amp would be lower then 230-240 . 

  • Like 1
Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • Welcome to the forum, enjoy. I have a varimatic that went  out of sequence because it’s hydronic oil ran very low. Must admit it’s still in my garage just know time to fix it. Purchased a cheap Indian Junta/ sonic Pearl as a stop gap a few years ago and it still performs perfectly so no incentive to fix the Varimatic. 
    • The plate is OK, thanks. It seems the answer to my question is that this is a 'hack' & for me another reminder that in general, one won't be the first person to be tinkering with an old timepiece!. As you day, I've been fortunate to have gotten some good advice and, just as important, encouragement. I've been lucky then not to have the balance spring break as a result of my novice 'ministrations' - but I did remember to 'stroke' rather than bend per se. The clock is of sentimental value to the owner so I'm relieved to have now got it running to time with the support & encourage of forum members like yourself.
    • Recently purchased a L&R Varimatic knowing that the piston does not fully rise in the cylinder. The likely cause is air in the system. The manual calls for using a bleeder cup, which is as rare as hen's teeth.Does anyone have any experience with this issue and if so, how did they resolve it?
    • Thanks ww, its maybe not as much of a bodge trick that i thought it was. 
    • Thank you for your introduction and welcome to this friendly forum. We all look forward to your contributions and continued involvement.  It would be nice if you told us a little about yourself.
×
×
  • Create New...