Jump to content

Recommended Posts

Hey everyone,

Another vintage tool from a long gone watch repair/jewellery business that I haven't a clue what it is or what it's for. 

It may be for a specific watch or clock, I don't know.

Both ends are squared/rectangular.

It measures 9cm / 3.5" from tip to tip.

The handle may be made from some sort of plastic...(?) I'm not sure.

No markings on it.

Anyone know what it is, and what it was used for?

pixlr_20190710124719871.jpg

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

  • Recently Browsing

    No registered users viewing this page.

  • Topics

  • Posts

    • Welcome to the forum  
    • I cleaned the hole thing, and oiled it using 9010 and hp1300. On the exit stone of the first pallet I put a drop of 9010, I've seen others using it although I now it's not the best there. I didn't oiled the second pallet. I have no photos of the timegrapher screen, and as I do not have a permanent desk I have uninstaled it. I'll take some photos next time I check the watch. But the data I gave is about what you can see there, the lines are very clean and nice in all positions except crown down, where they are quite messy. Lift angle was established at 53.0. I do not think there is any other relevant information you can see on the screen, is there?
    • Does your timing machine show a graphical display you can show us? Besides swapping escapement components what other servicing have you done to this watch? Plus what sort of lubrication are you using especially on the escapement components.
    • BLEURGH! Don't know how that ever became a "delicacy" in the Philippines!
    • We need a clear picture looking in sideways at the hairspring and balance wheel in the watch. Then yes technically her out a center but it's minimal it shouldn't be the cause of amplitude problems. They hairspring not flat would be a cause of problems especially when it's touching something. Can we get timing machine results? And that includes the graphical display with the numbers.    
×
×
  • Create New...