Mainspring and Winding Tools
Discussions on winding mainsprings back into the Going Barrel.
61 topics in this forum
-
- 3 replies
- 1.8k views
-
- 3 replies
- 1.7k views
-
- 0 replies
- 1.5k views
-
- 0 replies
- 1.5k views
-
- 4 replies
- 1.4k views
-
- 2 replies
- 1.1k views
-
- 3 replies
- 882 views
-
- 7 replies
- 662 views
-
- 1 reply
- 581 views
-
- 2 replies
- 519 views
-
- 4 replies
- 310 views
.thumb.jpg.cb17a66989f1e796fd4217db2e9ca9df.jpg)
-
Topics
-
-
Posts
-
By rjenkinsgb · Posted
Again, EDTA solution as I mentioned above, or Evaporust. They attack oxides but not good metal. After some hours, all the rust should have gone. -
Hi How can I clean this watch case rubber ring? It got the melted gasket on it... -
By Sebastiaan · Posted
Thank you for the reading material -
By watchweasol · Posted
Hi one assumes by the addition of the pictures you have the technical sheet for this watch. As mentioned by @HectorLooi center wheel canon pinion .take it down again and install only the parts required to set the hacking and turn the hands checking at each stage for correct operation. -
By watchweasol · Posted
Hi if it is a Swiss made watch badged by ingersoll (eubauches) ther is likely a makers mark and number under the balance that may help . If you open it up and post a picture of the movement plus Any numbers.
-
