Jump to content

Seiko 5m43-0a40


Fire3

Recommended Posts

Hi all

 

i have a Seiko 5M43-0A40 kenetic watch that had a suspected faulty capacitor, I took it to my local watch repair man who has advised me their is a fault with the movement due to a previous repair (I can’t for the life of me remember where I took it to get repaired previously)

 

The watch has a lot of sentimental value to me, what are my options for replacing the whole movement? 

 

Thanks in advance 

Fire3

Link to comment
Share on other sites

So, did the watch repairman say exactly what was wrong with the movement? as it is hard to advise you if we don't know what the problem is.

My opinion would be to take it to someone who will tell you what the fault is and how much to repair, otherwise you are making decisions based on lack of information. Knowing this will help you decide if it is certain parts that need replacing or the whole movement.

Link to comment
Share on other sites

The movement 5M43 is obsolete, but most parts are still available, so it depends on what is wrong with it as to your best option.

Repair the existing movement, or find a donor movement from a second hand watch, Jon says we need to what is wrong before we can give advice.

Link to comment
Share on other sites

Thanks for the replies, I’ve contacted the repair man, he says the coils were damaged when the previous capacitor was changed and they used a cheap replacement capacitor which has leaked.

 

I’ve found a Hattori YT63 movement that I have been told is a direct replacement is this correct? 

Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • Thats an AS 984  mike.   Found in the Enicar and Rotary ATPs
    • I'm going for an AS movement - the general layout, screw/jewel positions are similar.  
    • I haven't yet but I will take it out tonight! Thank you. Will post pics of dial side tonight too.
    • Did you have a look under the ballance? Often the movement maker/number is hidden there.
    • I wonder if 9415 is based on a base oil of 941? it's interesting what questions bring and the tech sheet answers it's the viscosity of the base oil. Then the impact? There is something we're missing here for that which would have a big influence on all of the house image above is 9514 image below is 941.then always interesting when specifications do not exactly agree? They ledge above for 941 indicates 110 viscosity but the image off the spec sheet is slightly less but I guess close enough   my understanding of the concern of too much 9415 is as we know the loss of amplitude. But why do we have a loss of amplitude? So impact it's basically oil should be very slippery. But what about non-impact? Like the edges of the escape wheel? Another thing that comes to play here is the shape of the escape wheel itself. Notice on the last a more vintage escape wheel with just a flat surface whereas the modern escape wheels usually made out of steel versus grass much much thinner their contact areas greatly been reduced and sometimes I think there even slightly curved. So is it conceivable at everything that isn't a flat surface on impact is going to be sticky? So this is where the shape of the escape wheel will have a big impact literally on how slippery things are. Oh and for all of you obsessed with worrying about too much 9415 I never worry about it because typically I'm doing pocket watches and it doesn't seem to be an issue at all. on the other hand I'm much more concerned about a watch that keeps time for 24 hours as opposed to the concern of the group of keeping amplitude for 24 hours. Then yes some pocket watches have steel escape wheels and do look like the escape wheel on the right.   
×
×
  • Create New...