Jump to content

Help With A Loose Vintage Minute Hand.


Recommended Posts

A controlled nip is required. For this reason I put them in a lathe collet and GENTLY tighten. It is really,really easy to go to far. You can use a broach but I recommend you put the broach in a vice so you have total control. 

Link to comment
Share on other sites

Clockboy the type of minute hand I mean has no stem just a flat hand with a hole to push onto the minute wheel. So there is nothing to place in the lathe collet. I'm thinking a stake of some shape to to close the gap slightly but not sure which would do it. Maybe a stake used for setting jewel stones would do it but that's something I've not tried either.

Link to comment
Share on other sites

Ok sorry did not read the post correctly. However I recommend to get hold of the Cousins catalogue and browse it.

There are lots of hands available , different styles etc.  You will need to know length,width hole size etc. Too small is Ok because you can broach the hole out to fit but to big I really don,t know a way around it. Using a staking set punch might be to much for a delicate hand. The cleaver boys (not me) would make another arbour with a fatter shaft or thin the minute arbour and put a sleeve on. But you need a watchmakers lathe and lots of skill which I do not possess.

Link to comment
Share on other sites

On a proper staking set you will find several hole reducing punches. The five blued punches with round polished ends are the ones I use to re-size hands. Smaller seconds hands as found on sub-seconds dials with tiny tubes I do with my set of pin vises. There are also other ways to accomplish this task, but I find these punches work well for me. I will post a photo shortly.

  • Like 1
Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • The plate is OK, thanks. It seems the answer to my question is that this is a 'hack' & for me another reminder that in general, one won't be the first person to be tinkering with an old timepiece!. As you day, I've been fortunate to have gotten some good advice and, just as important, encouragement. I've been lucky then not to have the balance spring break as a result of my novice 'ministrations' - but I did remember to 'stroke' rather than bend per se. The clock is of sentimental value to the owner so I'm relieved to have now got it running to time with the support & encourage of forum members like yourself.
    • Thanks ww, its maybe not as much of a bodge trick that i thought it was. 
    • Thank you for your introduction and welcome to this friendly forum. We all look forward to your contributions and continued involvement.  It would be nice if you told us a little about yourself.
    • Thank you for your introduction and welcome to this friendly forum. We all look forward to your contributions and continued involvement.  Can we help with what you are trying to  figure out? 
    • In think you are effectively shortening the coil by shorting out damaged tracks. In my case as long as the continuity was good and the resistance not too greatly affected it should be ok .  One was on an era  movement,
×
×
  • Create New...