Jump to content

1940's Tissot Wristwatch

Clochemerle
 Share

Recommended Posts

Clochemerle New Member

Clochemerle

Posted
Posted

I am looking at a friend's 1940's Tissot wristwatch. The watch runs well and keeps good time when worn and when laid in any position other than flat on it's back when it will gain 30 mins in 12 hrs. I can't see what is causing this. Does anybody have any ideas please.

Regards, Andy.

Link to comment
Share on other sites
Marc Distinguished Member

Marc

Posted
Posted

Have a look at the balance spring and see how close it comes to the balance cock.

When the watch is sitting face up or flat on its back the balance spring will sag slightly towards the balance cock.

If the spring isn't true in the flat and parallel to the balance, or if the collet isn't properly seated, then when the watch is face up the hair spring can come into contact with the cock, effectively shortening it and causing the rate to increase.

  • Like 1
Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • HectorLooi
      Battery

      By HectorLooi · Posted

      Usually the coiled spring contacts the piezo sounder and the finger spring is the ground.
    • Waggy
      How to store one dip

      By Waggy · Posted

      So I checked with my friendly local lab supplier and they can supply the following in 2.5 lt bottles: Tetrachloroethylene (B-Dip) - approx ￡65 Trichloroethylene (one-dip) - approx ￡43 n-Heptane 99% (Essence of Renata) - approx ￡35 Hexane - approx ￡45 I can't import or buy locally the 'real' products, hence the raw chemicals above. What do you think would be my best option? I'm edging towards Trichloroethylene - I know there are greater health risks, but given the very small quantities used for each treatment and 99.99% of the time it will be sealed in a jar, I think any risk is vanishingly small? This is mainly due to its assumed superior cleaning properties, or from the experience of this group, is the extra cleaning noticeable compared to its safer alternatives?
    • Kkramme
      Blew it with a coil

      By Kkramme · Posted

      Unfortunately after much investigation, apparently the coil has been discontinued! Shall I get my service guy to try the solder or the conductive paint? 🎨 Final recommendation please🙏
    • Dmitry
      Eta 2970-1 rotor mount stops watch

      By Dmitry · Posted

      Here are the pics of the bridge. Looks correct, but as soon as I screw on the rotor, the watch stops. Video here: https://1drv.ms/v/s!ArG5E62RGctxjokY5ws85BzuJLVakA   Pics. Might have figured it out. I have been working on this watch for a while and since I got it as a non runner in a terrible shape, there was no guarantee that parts were proper. I think the main screw that was used on the rotor was too long, so it was stopping the main train. As soon as I fished out a much shorter and larger headed screw, things were good again. Please celebrate with me.  
    • KarlvonKoln
      B-Dip residue?

      By KarlvonKoln · Posted

      One-dip or naphtha should be safe, but are you sure it isn't magnetized?  I would also check that.  Although, if that balance is from an Elgin 760 0r 761, I would think it would have a hairspring of non-magnetic alloy.
×
×
  • Create New...