Jump to content

Russian stopwatch

szbalogh

By szbalogh
in Watch Repairs Help & Advice

 Share

Recommended Posts

szbalogh Super WRT Addict

szbalogh

Posted
Posted

I got from a friend two russian stopwatch movements, both with broken balances. Moreower, i had one also which was half the parts missing but it has a case. So from the three i could make one working piece. Making new pivots should be an easy task now :)

But i cant find any service walktrhrough for russian stopwatches. Can you help me with that? 

2016-09-15_15.20.54.jpeg

Link to comment
Share on other sites
clockboy Distinguished Member

clockboy

Posted
Posted

It is highly unlikely you will find a walkthrough with this watch. You will have to take lots of pics as to dis-assemble the watch for reference when re-assembling. To state the obvious before dis-assemble let the power off the mainspring. There are many vids & tutorials on the net on fitting balance staffs & lubrication etc.

Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Levine98
      Chinese clone demagnetizers

      By Levine98 · Posted

      I’ve tried everything using both my blue and donut demag units.  I’ve even tried beating them with a steel hammer 🙂   im now trying heating them over gas flame — if that doesn’t work …..
    • Neverenoughwatches
      Chinese clone demagnetizers

      By Neverenoughwatches · Posted

      The 110v supply could be problem with the blue one. Have you tried moving the piece to demag through different orientations manually as its drawn away ? As Nev quoted the magnetic fields of the demag have to overcome those of the steel. 
    • Razz
      Elgin Excelle 17j auto

      By Razz · Posted

      Thank you Marc! I re ran the TG. First I went ahead and checked the balance jewel on the regulator and it was bone dry. I cleaned and oiled it, not without some drama including pinging the capstone and searching my bench with a black light for 30 minutes and finally shone it on my face and looked in the mirror only to find it on my left cheek in my 2 day growth! Back in and on the Grapher we are at 275. However significant drop in DD (234) and CR (190 edited) positions tells me it's time for a complete cleaning and oiling.
    • Levine98
      Chinese clone demagnetizers

      By Levine98 · Posted

      My $12 blue one seems to work well enough for movements out of case. However for  tools with greater mass, such as my small and large anvils which are highly magnetized the blue unit is useless.   For whatever reason, my high current K&D donut unit just doesn’t seem to work, regardless of my attempts to use it as instructed in this thread (magnetizes stuff fine so I know it is energized).  
    • Marc
      Elgin Excelle 17j auto

      By Marc · Posted

      PUW1563 is the day/date version of the 1561 (date only). I have just measured a 1561 using the old "blob of paint on the rim" technique to determine the actual amplitude by observation, and then putting it on my TG and adjusting the TG lift angle until the displayed amplitude matches the observed amplitude. I get 48°. Not a million miles away but it will have overstated the amplitude by about 20° with the TG set to 52° (I tried that as well for completeness). So with a more appropriate lift angle set on your TG you would have got an amplitude reading of about 240°.
×
×
  • Create New...