Jump to content

KIF Endstone size for Venus 188.

DBROWN
 Share

Recommended Posts

DBROWN Member

DBROWN

Posted
Posted

Hello all, 

I'm in the process of putting a Venus 188 back to together and discovered that the end stone in the upper KIF shock setting is missing. I also managed to make the shock spring fly away to neverland whilst I was fiddling with it.  Does anyone know the size of the end stone? Or the shock springs for that matter?  I can measure the lower end stone and see if it is will fit in the upper setting but i was not sure of the thickness as they can be different.  I can't find any documentation listing the Venus 188 and the KIF part numbers.

Thanks,

Darren Brown

 

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Neverenoughwatches
      Stem broken - can it be rescued?

      By Neverenoughwatches · Posted

      Not easy to find this one everywhere,  so it depends where you are located. Joining it back together might be possible, i have silver soldered mild steel before even with traditional plumbers lead and its a pretty strong joint, but bere in mind this is only 1mm diameter.  The join would need to be very accurate,  it not something i have heard of anyone trying before. The part no 401 is the swiss code number and relates to watch winding stems in general
    • Bonefixer
      AS2063 - hand setting

      By Bonefixer · Posted

      Thanks everyone for your helpful replies. I think between us we’ve worked out what’s going on. Next job is to have a proper look at this great wheel assembly, see if I can remove the clip and the friction fit pinion, give the bits a good clean, then put it back together with a bit of blue grease. I’ll also get the pallet fork under the microscope to see if it’s ok or been damaged. 
    • Mercurial
      AS2063 - hand setting

      By Mercurial · Posted

      The cannon pinion (be it conventional style or what you see in this movement) should slip on its arbour so the hands can be set independently without affecting the gear train.  If there is too much friction between the cannon pinion and the second wheel, turning the hands to set them backwards can sometimes force the escape wheel teeth to overrun the pallet stones, creating the behaviour you describe. The train is running in reverse when this happens.  This can often chip the pallet stones. I’d say at least half of the watches I’ve inspected with very tight cannon pinions had chipped pallet stones. Hopefully this isn’t the case with your watch.  I’m not familiar with this movement but you need to get the friction in the cannon pinion adjusted correctly.  Hope this helps, Mark
    • Bonefixer
      AS2063 - hand setting

      By Bonefixer · Posted

      Pallet fork was in. I’d had the movement running ok, and only removed the balance to flip it over and install the keyless works and date mechanism. The pallet fork wasn’t locking the gear train when hand setting - it was oscillating as the escape wheel rotated. This may have been in one direction only - can’t remember. 
    • watchweasol
      Stem broken - can it be rescued?

      By watchweasol · Posted

      Hi   Find attached parts/repair notes for the JLC 911,  might be useful. JLC_JLC 910, 911.pdf JLC_JLC 910, 911 Repair Notes.pdf
×
×
  • Create New...