Jump to content

Jewels

Murks

By Murks
in Watch Repairs Help & Advice

 Share

Recommended Posts

Murks WRT Addict

Murks

Posted
Posted (edited)

Thanks for all the help everyone I have question a want to change a jewel the outside diminsion is 1.10 mm and  the pivot size IS 0.9mm what size should I buy if a went on cousinuk should a go for 0.10mm for the pivot instead?

 

Edited by Murks
Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Neverenoughwatches
      Epilame / Fixodrop

      By Neverenoughwatches · Posted

      Yes i did eventually realise that the oil will act as a barrier, I'm sure the discussion will continue. Ive had two oleophobic coffees ( added coconut ) and in the meantime i have this just delivered to take my mind off epilame for the time being. My favourite type of dial, its a beautiful looking watch traditional English made and it runs,  the ticktock is phenomenal,  i can hear it across my living room .  You wont believe how much it was.
    • Albyon
      AS2031-57E solar panel - mission: impossible

      By Albyon · Posted

      Imm going to close the discussion by attaching the photo of my super-titanium after several vicissitudes finally working. Purchased as not working I replaced the battery and for a stroke of luck I found its semi-new solar panel which, having verified its operation, seems to recharge the accumulator perfectly. I had taken this watch almost by bet, with 40 euros I brought it back to life. The initial half idea was to resell it to finance another purchase, but.. it's definitely a nice item. It would need to check the impermeability but it's a pleasure to see it on the wrist 😃
    • Albyon
      Insert the movement inside the case

      By Albyon · Posted

      In fact the secret is to go gently and find the way without forcing, and the movement enters without problems
    • Murks
      2813

      By Murks · Posted

      Yea a have given it a full service this movement is chinese 2813 whats the lift angle for this movement does anyone knows  and how  do a remove the default  of 52 degrees on my timegrapher?   Hi you said my lift angle is default how do a remove this from my timegrapher?
    • VWatchie
      Epilame / Fixodrop

      By VWatchie · Posted

      Sure! Some very accomplished repairers never use epilame! I have often wondered if it is worth the trouble. Not using epilame will shorten the service intervals though, but that could be better perhaps both for the owner and the repairer!? Speaking of oiling, I just read this: After WWII in the 1950s the first Synthetic Oils came on the market. Most watchmakers did not rush to use these oils since they were bad for business now that the watch serviced with Synthetic oil would not come back to him for service for another 5-7 years he would lose a lot of income. ~Ofrei.com   Anyway, I wouldn't be surprised if it would be more correct to think of epilame as a binder rather than a repellant. Until convinced otherwise that's how I will think of epilame.
×
×
  • Create New...