Jump to content

Threads about forum policy.

Mark

By Mark
in Help & Support With This Website

 Share

Recommended Posts

Mark Distinguished Member

Mark

Posted
Posted

Forum policy will not be discussed publicly on the board. If you have suggestions or concerns then kindly contact a member of the volunteer Moderators or Myself via PM.

To those who have strong opinions on how Moderators (all of whom volunteer their free time to help support this project), then I would say - you are welcome to put your hat in the ring and volunteer yourself, I have on several occasions in the past invited people to apply and rarely does anybody step up. None of us are getting paid to do this, the website barely breaks even financially (despite people complaining to me about ads) and so its disheartening when people complain.

So back to the subject of this post - Suggestions on policy are very welcome, but not publicly as I don't want arguments or divisiveness. Policy suggestions from members will be discussed by the team and decided upon.

Thank you.

  • Like 6
  • Thanks 1
Link to comment
Share on other sites
  • Mark locked and pinned this topic
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Neverenoughwatches
      Hello from Wales, UK.

      By Neverenoughwatches · Posted

      Ah so its you thats buying up all the DD calibres 🤨.
    • B1N9S
      Hello from Wales, UK.

      By B1N9S · Posted

      Hi Richard,  I keep buying CAL.59 movements to practice on 🙂 Not started yet though, I'm gathering tools and building my confidence to start.
    • AndrewSi
      No main barrel endshake on Waltham model 1900

      By AndrewSi · Posted

      Problem solved. For some bizarre reason, the hook on the wall of this barrel is not properly centered vertically, but is oddly high on the wall, maybe 3/4 up the way up. When replacing the mainspring, this caused the outer coil to be displaced upwards as well such that it protrudes out of the barrel and caused the barrel lid to not sit quite flush to the barrel. Since this is a motor barrel, the lid is actually the first wheel and inner coil tube/hook all in one piece, with no “snap down” action that would have made the problem more immediately obvious. Maybe with an older mainspring the spring’s end hole was enlarged such that this wasn’t an issue, but hard to say how it ever worked otherwise. Replacing the barrel with one from a different model 1900 where the hook was properly vertically centered allowed the lid to sit flush without mainspring interference and the friction problem went away. The bridge was far too thick to be bent (and isn’t), for those of you thinking that was the problem. Placing the removable arbor in the watch without the rest of the barrel proved that the proper end shake was actually there as long as the overall height of the assembled barrel was correct.
    • Jon
      Mainspring winder question.

      By Jon · Posted

      You are so true on a lot of what you have said. The main reason for changing the mainspring even if the old one is in good order is because it will take out your thinking that the mainspring is contributing to poor power output or fluctuations in amplitude. If a new spring is fitted that box can be crossed off as a potential source of a problem. Most customers are happy to pay the extra ÂŁ20 for a new mainspring if they are already parting with a couple of hundred pounds for a service. A new spring is an investment for good running for the future.
    • nickelsilver
      LeCoultre Memovox dial and escape wheel.

      By nickelsilver · Posted

      According to Borel the 814 and 815 use the same escape wheel. It's kind of an oddball being so long.
×
×
  • Create New...