-
Recently Browsing
- No registered users viewing this page.
-
Topics
-
Posts
-
the hardware works fine, but I need to work on my side of the equation, have squashed a few cannon pinions trying to find that 'Goldilocks' zone between too much force and not enough.
-
My Horia clone is 4/4mm, I have seen 3/4mm on Ali but the 4/4mm is the more useful imo Tom
-
The Horia clones seem to have 3mm pushers and 4mm stumps - at least the ones I’m looking at have that listed in the specs. But who knows, perhaps there are various iterations and most don’t list their specs. I can’t find the specs for the 31001 listed anywhere. Would you be able to measure the diameter of both sections and us know? I suspect - but I don’t no for sure - that the stump is 4mm and the pusher is 3mm too. It would be interesting to confirm. Thanks Malocchio.
-
Do they actually make the Horia clone in 3mm too? Mine is 4mm both sides and I thought they all are. Yes 31001 fits the 4mm model and works great. I use it for seconds hand tightening too.
-
By trenchwatchww1 · Posted
have measured up and movement looks to be 28mm diameter...a number of silver case reads 237516 there is a nother mark i cant make out
-
Recommended Posts