Jump to content

Old Waterbury

JerseyMo

By JerseyMo
in All Things Clocks

 Share

Recommended Posts

JerseyMo Distinguished Member

JerseyMo

Posted
Posted (edited)

Given that Waterbury was the founding company of Timex, this one was a must have for me. far far I have it ticking again.  See the attached clip.

 

1528803170_waterburyclock.jpg.3e742d57ccbb80f40203101bf804fb5f.jpg

Edited by JerseyMo
  • Like 3
JerseyMo Distinguished Member

JerseyMo

Posted
  • Author
Posted
9 hours ago, oldhippy said:

That little movement has a good action. Hope it’s like that at all angles.

the movement ran overnight so I decided to assembly it back together.  Interesting enough when I began to clean the hands I found they were hand cut so assume at some point they were changed.  The clock case has been clean and everything  is all back together now and ticking away nicely.  So for the first project off of my new \ old bench this one was lots of fun.

done.jpg

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • dnhb
      Loose pinion

      By dnhb · Posted

      I've gone the threadlocker route having tried the material insert approach without success. The watch runs but I'm chary about winding it more than a turn or so in case the 'repair' gives way; still, there's an element of satisfaction in getting it going at all as it's a single bridge/plate design which I could only assemble dial side up & then flip over in order to be able to insert the 3 securing screws. The reassembly took a number of attempts over many hours but at least I got considerable manipulation practice & the experience will come in useful in future. I'm now faced with my ignorance about how to manually set the the time as this key-wound Waltham pocket watch doesn't have the usual pull-out stem facility. All I can think of doing is to adjust the regulator arm until it catches up with the current time & then revert to the central position.....
    • AndyGSi
      Omega Cosmic 2000 split stem question

      By AndyGSi · Posted

      So the crown should be a 0.9mm thread as you've ordered. How do you know the thread size is wrong if you've not removed the broken stem yet?
    • AndyGSi
      Where it begins

      By AndyGSi · Posted

      You'll need to be extra careful with the Citizen as Information along with Parts and Donors are pretty much none existing. You'll probably end up having to use a stem extender, that's hoping there's enough stem left in the movement.
    • Embezelled
      Where it begins

      By Embezelled · Posted

      Thank you! That's immensely helpful. I appreciate the trouble you've taken. The initial hiccup aside, I do hope to treat this watch with great care and respect. I've certainly learned one thing not to do, and also just the general need to start out very slowly and very carefully.    
    • Shadaar
      Omega Cosmic 2000 split stem question

      By Shadaar · Posted

      166.128 is the case reference number and the Omega logo is on the crown. This is the watch.
×
×
  • Create New...