Jump to content

Broken watch hand

Sam79

By Sam79
in Watch Repairs Help & Advice

 Share

Recommended Posts

Sam79 New Member

Sam79

Posted
Posted

Hi,

Can anyone please advise me on identifying and sizing broken watch hands. I recently received a project watch (spares or repair) and the minute hand was broken with a part of it laying inside the glass.

I've removed it, but have no idea on how to identify the fit type, style or size of the hand. 

Any help would be much appreciated.

Thanks.

 

IMG_20190217_194922.jpg

Link to comment
Share on other sites
TexasDon WRT Addict

TexasDon

Posted
Posted

If you're completely new to watch tinkering, it can be a bit intimidating at first.  Each watch usually has an identifying model number or as is referred to in horology, a caliber number. It will usually be noted on the case back. Occasionally it's on the dial but almost always on the movement itself. Once that is known, an internet search should reveal the size hands needed. If you like, post a photo of your movement here and you'll get plenty of help identifying the hands.

Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Neverenoughwatches
      Stem removal after fitting hands

      By Neverenoughwatches · Posted

      So leave off the seconds. Stand the movement on its edge, its the dial edge that rests on the pad ( either rubber or cork , something that wont slip ). Use a finger of your left hand to hold the movement upright,  right hand presses the release and flicks out the stem. I do it this way so i can see what I'm under a microscope. But you could hold the movement between two fingers of your left hand, its the right that has to manipulate the stem out by pushing the release and flicking out the stem with  right ring finger nail. Sounds more complicated than it actually is. I guess you could fix a push pin to something solid, then all you need to do is push the release against the pin, leaving your right hand completely free to pull the stem out.
    • HectorLooi
      Battery

      By HectorLooi · Posted

      Try putting everything back together and closing the back cover. I think one of the two springs has to contact the metal casing to ground the casing. So when you press the button, it will touch the contact on circuit board and close the circuit.
    • PeterS
      Stem removal after fitting hands

      By PeterS · Posted

      Yes, the seconds hand is the longest and goes almost to the edge of the dial. I can’t quite picture it how you do it on the rubber pad
    • Murks
      Battery

      By Murks · Posted

      A don't think so it leaked or damaged it because the watch itself works it just the buttons ain't working not connecting with the circuit board have taken more pictures of where the buttons makes contact with the circuit board.
    • Neverenoughwatches
      Stem removal after fitting hands

      By Neverenoughwatches · Posted

      I think what peter means oh is once he has fitted the hands and  checked for  alignment if them and that they dont foul, how does he then hold the movement to remove the stem in order to case up. The dial cannot be laid on a cushion or in a movement holder as the hands will get damaged. This can be quite tricky for a beginner, what i do is  to stand the movement on edge on a rubber pad so it doesn't slip. Hold the top edge with one finger then my dominant hand uses 3 fingers to press the stem release and flick out the stem. See below peter, leave off the second hand as this is the longest and gets caught the most, then fit it once the stem is out. Alternatively place the movement in one of the cup style holders, i imagine this is what they are designed for. They only touch the very edge of the dial.  
×
×
  • Create New...