A Couple From The Bottom Drawer..
-
Recently Browsing
- No registered users viewing this page.
-
Topics
-
Posts
-
By nevenbekriev · Posted
I think that if this is a spring wire like piano string or similar, it will not break and wili be srong enough. What You could do is to drill straight with 0.5 . Then it would be beter, but now it is good enough to do it with 0.3. -
By Neverenoughwatches · Posted
I knew you would say that, i was thinking the same , i wasn't particularly happy about opening up the hole. Should have gone with the 0.5mm to start. On the positive side i now know i can drill a hole for a 0.3mm pivot, looking at it through x25 while i was drilling it looked MASSIVE 😃 -
By nevenbekriev · Posted
Enlarging the hole is dangerous and it is almost sure that the drill bit will break inside and it will be hard or even impossible to get the broken pieces out. 3X diam is enough. Just prepare the piece that will get in the hole in a manner that it will have 0.3 X10 part that will enter the hole and wide part that will be outside and will be able to turn it tio size. -
By Neverenoughwatches · Posted
No i haven't started to do that yet Nev, i wanted a bit of feedback first. I think you're going to tell me to turn the pivot hole spigot down to 0.3 , i thought that would be too small and weak though -
By nevenbekriev · Posted
Now don't hurry to enlarge the hole to 0.5. Hope I am not late saying that.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.