Jump to content

Seiko Quartz #'s and Replacements

mcass
 Share

Recommended Posts

mcass WRT Addict

mcass

Posted
Posted

I have a Seiko SQ here that I've been asked to repair. The crown is missing and it just seems to me possibly it may be just as simple to replace the whole movement rather than just stem and crown. Regardless I would assume budget to be similar.

My question is in regards to the 5Y22-8A08 number. What exactly is this identifying? I've seen many 5Y22 but the other 4 id's are different. Any suggestions would be appreciated!

Sent from my iPhone using Tapatalk

Link to comment
Share on other sites
bobm12 Distinguished Member

bobm12

Posted
Posted

You are correct, as CB said the movement is the first "characters" before the dash. I would suggest to measure the height of the original movement since some movements come with different total height. Other than that, any 5Y22 with the same height (in case they vary) should be good.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Michael20
      Questions about my Bravingtons Renown Mantel Clock

      By Michael20 · Posted

      I was wondering whether anyone could assist with some questions I have about my latest acquisition, which is a two train ‘Bravingtons Renown’ mantel clock - Pics attached I have done some reading about Bravingtons and believe they sourced movements from various suppliers, so I wondered whether anyone recognises this one. I have stripped and cleaned the movement and the clock is now running well, but there are a couple of dodgy brass springs that I would like to replace. I haven’t found anything suitable searching the internet so I wondered does anyone know of a supplier that might help. Last question is about the veneer on the case, it is generally in reasonable condition but there are a couple of patches on the top where the veneer has lifted. So far, I have tried to reactivate the existing adhesive by heating from below and above with a hair drier, then clamping for a day or two. It has improved slightly but the bulge is still visible. I’d be grateful for any advice if anyone has dealt with this sort of repair before.
    • watchweasol
      Insert the movement inside the case

      By watchweasol · Posted

      Hi some pictures o& the movement and case would be appreciated so we can ascertain what the problem is you are having in fitting the movement.   Thank you.
    • dnhb
      First pendulum clock tinker

      By dnhb · Posted

      Thank you very much,T. I'll try turning the arbour from the clock face end very carefully in case I haven't reassembled the suspension block correctly (I had to make up a suspension spring using remnants of a broken one as I haven't been able to find an exact replacement online).
    • watchweasol
      Digital Watch

      By watchweasol · Posted

      Hi murks a picture of the front as well would help,   By the size of the plate it was stuck to I would suggest a coin cell,  2030,  2015 all depends on the height of the cell. And the space when the back is fitted.         3 volt. 
    • Neverenoughwatches
      Without Our Forum

      By Neverenoughwatches · Posted

      We seem to have gone a bit quiet on this ?  Do we all agree to ask Mark for some input on this matter, or is no-one really bothered. 
×
×
  • Create New...