Jump to content

How To Remove A Watch Face

Tigertim
 Share

Recommended Posts

Tigertim Member

Tigertim

Posted
Posted

I am new to watch repair as a hobby ,at the moment I am trying to dismantle an Atrexa winding watch but I dont know how to remove the face (where the screws which hold it on are located)

Any help would be much appreciated

Link to comment
Share on other sites
Mark Distinguished Member

Mark

Posted
Posted

The dials are usually held via tiny dial screws around the edge of the movement. Some movements (older ones) have the dial screws on the underside and require a small turn to release the dial feet.

 

Do you have a picture of the movement?

Link to comment
Share on other sites
Mark Distinguished Member

Mark

Posted
Posted

This is very likely. Don't undo them all the way - you will risk losing them. Unscrew them until you feel the dial getting loose - start with half a turn on each side.

 

I hope this helps.

Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • swiss2k
      Omega cal. 565 - low amplitude

      By swiss2k · Posted

      No matter what I did, I could not get the amplitude more than 240 deg. At least there is 0.2 beat error and minus 1-2 s/d.  So, probably not the happy end I would have hoped for, but still I think the watch turned out quite nice. You be the judge of that. Thank you everyone for your help!  
    • transporter
      First pendulum clock tinker

      By transporter · Posted

      its used to lengthen or shorten the suspension spring from the front f the clock dial, this in turn will give regulation to the clock. Try inserting a pocket watch key or even better the double ended key for the clock into the small aperture on the dial at the top and turning it, you will see the suspension block either raise or lower. If it raises the clock will run faster if it lowers the clock will run slower
    • dnhb
      First pendulum clock tinker

      By dnhb · Posted

      Grateful for info regarding the nature & function of the horizontal cog and the unit it's on top of in the picture. It meshes with a vertical cog (enclosed in the unit) on the arbour which is supported at its other end by the back plate of the dial unit to which it is not quite perpendicular...
    • Murks
      Digital Watch

      By Murks · Posted

      does anyone knows what type of battery this digital Watch takes?  
    • Neverenoughwatches
      Second hand watch market.

      By Neverenoughwatches · Posted

      Hello good watch folk ,I  just fancied a light hearted discussion after my head was starting to spin over Epilame 😅. Specifically I'm meaning the sale of vintage watches, say nothing past the 1980s market. The stuff we see on ebay and other similar sites and found at carboots, curio shops etc. And are  we thinking its reaching a peak volume ?  Younger generations clearing out passed parents and grandparents possessions.  The younger folk are not as sentimental as the old fogies ( I'm now nearly at an age that i used to think was old fogie age ). When might it have started ?  i often wish i discovered the hobby much much sooner when selling your grandfathers pocket watch at a boot sale for a few quid was just a way to offload some tat. And when might it slow down. Thoughts anyone ?
×
×
  • Create New...