Jump to content

gruen swissonic stem removal

ramrod

By ramrod
in Watch Repairs Help & Advice

 Share

Recommended Posts

ramrod Super WRT Addict

ramrod

Posted
Posted

i recently received a gruen swissonic electric watch.....actually, i received 4 of them last week - 2 gruens and 2 generic swissonics. only two of them are runners.

i wanted to pull the stem on the nonrunners, but i don't know how to do it. apparently,  they're two piece stems, but i can't tell where the joint is on the stem. mine look like one piece stems.

this question was posted on the "watch of today" thread, but i figured that it would be a better idea to post it here. noirrac1j posted a picture of the movement in question, but i can't see clearly what i need to do because i can't enlarge the picture. noirrac1j - could you please post that picture here only enlarged?

i will post a picture of the watches and the movements a bit later.

Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Neverenoughwatches
      Pallet jewel

      By Neverenoughwatches · Posted

      The entry and exit stones have different impulse face angles  murks.
    • Waggy
      First Project Already A Bit "Sideways"

      By Waggy · Posted

      Depending on how much of the screw is left, you may be able to screw it further in and it may fall out of the hole that the dial foot sat in. To do this I rough up the tip of the good screw and screw it in, often the rough surface of the good screw and the rough surface on the broken screw get enough of a bite to transmit the torque into the broken section and force it out the other side. Like I said the size of the broken screw needs to be in your favor, but you never know you may get lucky.... or if you get it moving you may be able to then back it out with a screwdriver taking a bite on the rough surface. worth a try
    • DDean
      First Project Already A Bit "Sideways"

      By DDean · Posted

      I will try this weekend.  I've tried several times with my cell phone and it's just too small and recessed to get a good picture.  I need to get my macro lens and tripod out and then figure out how to get enough light down the hole in the side of the man plate to  actually show the top of the broken screw. I appreciate the effort and will try and get that pic this weekend.
    • RichardHarris123
      Simeon from Down Under

      By RichardHarris123 · Posted

      Hello and welcome from Leeds, England. 
    • Simeon
      Simeon from Down Under

      By Simeon · Posted

      Hi,   My name is Simeon I am based in Sydney, Australia and have recently got into watch repair / watch making.  I am very much a learner having serviced multiple forgotten watches, some of which were actually successful!   I have a slowly growing collection of watches, mainly old Soviet, a few Japanese and (not pictured) some Raketas, a Poljot Alarm, an Omega Speedmaster Reduced and a vintage (1972) Tissot Seastar.  I like unloved vintage watches, with quirky faces and enjoy bringing them back to life through the simple(!) act of disassembly, clearing and reassembly. I am an Electrical Engineer who also undertook a trade apprenticeship so I am reasonably handy - It's fair to say, I know just enough to get myself in trouble. 
×
×
  • Create New...