Trouble Finding A Gasket For A Mrp Sa Case
-
Recently Browsing
- No registered users viewing this page.
-
Topics
-
Posts
-
Haven't you tried bringing them to your local tip (Waterdale (Garston) Recycling Centre)?
-
Alright!! My big project has started. I'll start a walkthrough thread about it soon. But about the barrel. Here are some pics from my microscope. Can you tell from it if it's ok to open (and close again)? To my, frankly, it looks like it can.
-
I've been using these in my Seitz press. I like the micrometric control and never had any issues (in the two cases that I tightened canon pinions 😅). I think they work fine for wrist watches. My intuition is that it's not supposed to be too sharp. It should compress a wider section of the canon pinion. If it was very narrow, I could imagine the inner tight part wearing out again quickly.
-
By rossjackson01 · Posted
Can't do alum as the arbour is metal. I did try a drill in my dremel. But was unable to hold it secure. Need a lathe. Still thinking about one of those 9 in 1 lathes on Ali. -
By Neverenoughwatches · Posted
All the seitz anvils and pushers fit the 4mm clone and I use my Star stumps in the clone base as well. Its not a definite answer but Bergeon and Star lathe accessories are compatible so its possible the staking tool is the same fit. Try contacting Cousins for an accurate measurement.
-
Recommended Posts