Jin999 Posted September 14, 2020 Share Posted September 14, 2020 (edited) Hi everyone, I am working on my first self servicing of vintage manual wind Tissot. I am stuck and hoping the seniors here might be able to give me some guidance. The issue is, i had no idea how to remove the drive wheel during disessembly and how it should be install back during assembly. Much appreciated. Kind regards Jin Edited September 14, 2020 by Jin999 Link to comment Share on other sites More sharing options...
anilv Posted September 15, 2020 Share Posted September 15, 2020 You need a wheel puller (see link below). I don't have one so I use two flat rods (sourced from inside a car wiper blade) bent and thinned down at the edge. You can also slide a flat blade under and worked your way up but be warned ... your chances of breaking the shaft is high... slow and easy and rotate the wheel as you go so it comes off straight. https://www.esslinger.com/bergeon-3-presto-sweep-wheel-remover-5-spoke/ Anilv Link to comment Share on other sites More sharing options...
Recommended Posts