Jump to content

Omega Balance Staff


Recommended Posts

 

 

 

 

Hello fellow watchlovers

I'm a very amateur watch repair guy. I have an omega pocket watch that was converted to a wrist watch. The balance staff is broken on the hairspring side. I have lots of watch repair equipment but I am having trouble sourcing the new balance staff.  Any idea's would be much appreciated. I do have an old boley lathe with the collets but I have never turned a balance staff and not sure I want to attempt that yet.

Thanks for checking it out

Shawn

 

 

 

IMG_6027.thumb.JPG.7378f5a18b95d2fc5ea3f92be85fa51e.JPG

IMG_0537.JPG

IMG_0537.JPG

IMG_9706.JPG

IMG_1342.JPG

IMG_9208.JPG

Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • Good news is that the arbour is very hard and the screws are much softer material, so drilling out is a viable option Unfortunately we can't do the alum trick.
    • Thanks Ross, yes i remember the broken arbor screw you had to deal with. Dont give up, if i can drill a tiny hole in a bloody hard barrel arbor without breaking the drill bit then you'll get that screw out one day somehow .
    • Isn't it most correct to say that the mixture of radium decay pathway compounds found in old lume will produce both alpha and beta particle radiation as well as gamma rays, so it's over-simplistic to dismiss it all as low-energy particle emission? True, a cheap geiger counter chirping away with a raw CPM count won't specifically give you the relevant biological dose, but it makes it easy to tell the difference between your local background, a watch with a bit of activity, and one that is comparatively quite active. Each person can make their own risk analysis based on their understanding and concern, but there's nothing wrong with using an inexpensive meter to help make the determination.
    • A lesson I learned last month on a Junghans pocket watch where both pins were bent over like stalks of wheat in the wind. I bent them back straight, wondering what a shock the thing must have taken to somehow bend even the outside pin over. And then the escapement wouldn't unlock at all. Probably the pallet stones are too long but I'm not ready for that repair yet so I bent the pins back over and it runs 0/0.2
    • Never. Brilliant work and photographs. Thank you. On my very first watch I knackered the arbour. I think the screw I put in was the crown screw. I didn't know about left handed screws then. Head sheared off. Thread broken just below surface. If I had the space, then a lathe would be my wished purchase. 2 1/2 years later and I still get the arbour out now and again and...... I can dream. It's a lovely pocket watch. Ah well. 
×
×
  • Create New...