Jump to content

Recommended Posts

Posted

Welcome to the forum.

If you can get it out a bit you'll need to apply some upward pressure as you unscrew it.

The problem then could be if the hole is stripped how it will go back.

  • Like 1
Posted

Hi. Run a little wd40 under the screw around the flange and leave it for a while then re try. If it’s just turning on a bad thread  put a screwdriver under the flange and apply a little pressure upwards and unscrew whilst under pressure

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...