Search the Community
Showing results for tags 'sellita'.
Found 2 results
-
Hello, I'm building a watch using a Sellita SW200 and I bought an ETA 2824 dial. The dial has four feet and so does my movement, but they don't line up, the ones on the dial are too far apart relative to the movement. I think if I cut off two feet I can make it fit but I'm not 100% sure. Is this a common scenario? -
I recently purchased a sellita sw-200-1 movement and it was working fine. When I wanted to recase it the stem went loose and I had to reassemble the keyless work to get it to work properly. I then realized that the movement stopped working. Upon further inspection I found out that the escape wheel isn't engaged with the second wheel. The escape wheel is also very loose on the top part close to the bridge. Do I have to replace my escape wheel and what seems to be the problem? Is there a pin at the top which was sheared off? Thanks. VID_20180304_231841.mp4
