Jump to content

Seiko 6309-510A bezel gasket


Nednico

Recommended Posts

Is a really interesting website found at the first link below. Normally when I go there I go right to something lower down where it gives you starting letters of the various watchmakers so you can look up cross reference of watch parts.

http://cgi.julesborel.com/

Now at the very top there's a search feature and if we enter in this   SEK CS#6309-510A. We get the link below which casually doesn't look helpful because we seem to be missing some numbers except if you click on the items you will tell you all the cases that cross reference with that item and at the very top you get a number. I'm not exactly sure which gasket you need see you may have to do a little research but at least you get some numbers. 

http://cgi.julesborel.com/cgi-bin/matcgi2?ref=SEK_CS^6309-510A

 

 

 

Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • Hmmm you know when i said some damp might have caused the bubble originally hmmm 🤨
    • Are you all jerking my chain, I'm a yorkshireman £4.04 is too much 😆
    • [Myota2034] Custom simple quartz watch — PricewaterhouseCoopers On a very very different note, here is a watch from approximately 2000 when I was a Partner with PwC, Management Consulting. It was a simple “marketing watch” with a clever “vase of knowledge” that is subtly revealed on the dial as the second hand progresses. Clever for a simple watch!⌚️
    • I think someone else has though. Some where here using a modified perspex sheet. I may be wrong i may be right , i think it involved fitting the arbor to a pin vice. I dont have experience of the bergeon winders, are the handles not interchangeable ?
    • Never tried dial dots, i always considered them as a bit of a bodge.  You are adding something that was never intended to be there. I wonder how the adhesive reacts to any part of the movement, hot summer heat and i think things might turn sticky. Most adhesive backed stuff has a tendency to soften and slide around so it may spread, i have used a lot of so called sticks all adhesives in my industry that are just not up to the job. I suppose they get you out of a problem quickly, but how permanently might that be ? I would just explain to the owner that it may or may not work. WWs other ideas are a much more permanent solution but both have their risks . I've tried milling and dial feet replacements, hmm it was ok, ive heard of folk dimpling the face , so that needs care . And i have soldered a few times , all with good results but i am very careful and I practiced it a lot.
×
×
  • Create New...