Landeron 48 help!

[Bonefixer]

I'm fixing up another Landeron 48 - this will be my 4th one of these so I'm getting the hang of these a bit. I got it as a non-runner (pallet fork pivot broken, barrel tooth broken) and replaced those so that it runs ok. 
 

Reassembling the chronograph I've hit a snag. The watch stops when the chrono is engaged. I think the teeth are too deep. I think the eccentric to adjust that is on the hammer, circled in the picture. It won't move. Any suggestions?

[nevenbekriev]

Nop, the eccentric You need is where the red arrow points. Hopefully it will move.

[Bonefixer]

Thank you. That's solved that issue. Centre wheel now runs. A bit more work needed to adjust the minute finger depthing now, and possibly a bit more lube. But nearly there.