Zenith pocket watch service
-
Recently Browsing
- No registered users viewing this page.
-
Topics
-
-
Posts
-
By Neverenoughwatches 路 Posted
I understood it that the op wants to reduce the lip height, in order to lower the movement in the case, nothing to do with the diameter. -
In the end I got a balance from a donor movement. Fitting the collet back on is not that difficult. If you are not confident, get an old scrap balance and practice on removing and refitting the collet. -
As it's so close to the 25.6 stated you should be able to run a fairly smooth sanding drum around it. -
Thank you @RichardHarris123, @AndyGSi for your ideas. You鈥檙e right, sorry for confusion That鈥檚 a good point, I forgot mention that the internal hole has three different diameters: 27.5, 25.7 (middle ridge that I鈥檓 trying to cut) and 26.1 It doesn鈥檛 go through the hole because of 25.7. I think I can align and fix with clamps once the ridge is removed 25.7 -
From your annotated image, I was able to locate it, but I hadn't been able to ascertain the bend. My unsophisticated eye wasn't looking for a slight twist, which I think I see now. I'll go back and read the referenced posts as well, since they will likely help me understand in greater detail. Maybe I'm making things better?
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.