re-seating an incabloc spring
I might need some tips here. I lifted the incablocc spring to remove the balance jewel on a Unitas 6498 Clone (Seagull 3620) non dial side when the spring unseated from the housing. Any tips on getting it to seat again, any known videos on a technique. I recall Mark warning about this on an instruction video and so I took extra care but...
Are all movements subject to this kind of drama when removing a balance jewel or just on the Unitas clone?
Appreciate anyone's experiences at all.
So I have far too many pictures to go through but I haven't given up but in the meantime I'll try to explain taking something out of the video above. So the very beginning it shows how things go together. At around 11 seconds to get a silhouette. If you look at the image I have attached notice I drew a red line and then look at the video you'll notice that the tail end of the Gold spring hinges In that convenient slot. Because there's a slot spring almost never comes out. But in the Chinese vers
