Jump to content

Help With A Loose Vintage Minute Hand.


Recommended Posts

A controlled nip is required. For this reason I put them in a lathe collet and GENTLY tighten. It is really,really easy to go to far. You can use a broach but I recommend you put the broach in a vice so you have total control. 

Link to comment
Share on other sites

Clockboy the type of minute hand I mean has no stem just a flat hand with a hole to push onto the minute wheel. So there is nothing to place in the lathe collet. I'm thinking a stake of some shape to to close the gap slightly but not sure which would do it. Maybe a stake used for setting jewel stones would do it but that's something I've not tried either.

Link to comment
Share on other sites

Ok sorry did not read the post correctly. However I recommend to get hold of the Cousins catalogue and browse it.

There are lots of hands available , different styles etc.  You will need to know length,width hole size etc. Too small is Ok because you can broach the hole out to fit but to big I really don,t know a way around it. Using a staking set punch might be to much for a delicate hand. The cleaver boys (not me) would make another arbour with a fatter shaft or thin the minute arbour and put a sleeve on. But you need a watchmakers lathe and lots of skill which I do not possess.

Link to comment
Share on other sites

On a proper staking set you will find several hole reducing punches. The five blued punches with round polished ends are the ones I use to re-size hands. Smaller seconds hands as found on sub-seconds dials with tiny tubes I do with my set of pin vises. There are also other ways to accomplish this task, but I find these punches work well for me. I will post a photo shortly.

  • Like 1
Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • That would be something! Which brings me back to;  
    • you think you're going to sleep tonight you're not, you're going to ponder the question of what makes you think those of the right parts?  
    • Does anyone knows what size case a need for a dial diameter 20.60mm?
    • Sounds like the story with my Rolex. Poor (expensive) job done by an official Rolex dealer with an "in-house" watchmaker, hence I learned watchrepair and did the servicing myself. Same story as I learned with the Omega 861, again poor job by an "in-house" watchmaker by an official Omega dealer. Once your watch goes through that back-door, you have no idea what is going to happening to it 🫣   Quite nice that they sent back the parts which had been replaced !
    • yes that's definitely not right at all. I have a picture one of my friends has a Omega coaxial there was having issues to lose asking me where he should send it. As that's a specialty watch I suggested the service center. When he got it back he sent me a picture so the replace the dial as you can see the hands the mainspring barrel and I think the price was really quite decent considering all the stuff they can replace. So I do know they do change the barrels but the other person I worked at the service center when I would ask questions and unfortunately I can't remember all the answers. I think a lot of the changing a parts is at the discretion of the watchmaker. Plus I don't know enough about the chronographs and whether that would be considered a vintage watch? I take some of the vintage watches may have been sent directly to Switzerland or another service center. Obviously with a watch like the one down below they probably have a infinite supply of parts is its relatively modern vintage stuff becomes more interesting even the watch companies don't have necessarily infinite supply of parts. But no matter what the watch shouldn't disintegrated six months that's definitely an issue.        
×
×
  • Create New...