Jump to content

Make a screwhead?


rogart63

Recommended Posts

I've done so with a very fine slitting saw in a mill with some success, but the screw was large compared to watch sized (more like pocket watch/travel clock).  I' have some the of the files for the screw slot as in the link below.  I think I tried it once with the file and concluded it is bloody difficult and the file seemed too big.  It needs a very steady hand and I think a largish pocket watch sized screw to work, at least that was my limited experience with it. 

https://www.eternaltools.com/screw-head-slotting-file

Edited by measuretwice
  • Like 1
Link to comment
Share on other sites

7 minutes ago, TimFitz said:

It sounds like your trying to clean up screw threads is that correct? Or the slot for installing the screw?:)

 

We tried to make a new screw for a setting lever spring where the old one had a bad  thread . So made a new thread but couldn't find a low enough screwhead to clear the dial. i tried to make the head a little lower by putting it in a pin vice. That worked but the slot for the screwdriver was also removed. So was only wondering how we could make a new one. Just for fun to know and maybe have some use for some other day :) 

Edited by rogart63
  • Like 1
Link to comment
Share on other sites

4 hours ago, rogart63 said:

We tried to make a new screw for a setting lever spring where the old one had a bad  thread . So made a new thread but couldn't find a low enough screwhead to clear the dial. i tried to make the head a little lower by putting it in a pin vice. That worked but the slot for the screwdriver was also removed. So was only wondering how we could make a new one. Just for fun to know and maybe have some use for some other day :) 

Thanks for clearing that up. So as " rodabod " said , a slotting file.

Link to comment
Share on other sites

6 hours ago, StuartBaker104 said:

Here are a couple of options

https://www.hswalsh.com/product/slotting-screw-head-file-cut-4-hf71

https://www.esslinger.com/screwhead-file-with-tang-makes-slot-in-top-of-screws-swiss-vallorbe/

Ideally you would put the screw in a lathe and use a double roller file rest to keep the file in the right place

 

Seen that done somewhere on the internet. But think i can arrange something on my lathe. have an old unimat . So can probably make some kind of support for the file to rest upon . 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...