Escape wheel not engaged

[SeeJianShin]

I recently purchased a sellita sw-200-1 movement and it was working fine. When I wanted to recase it the stem went loose and I had to reassemble the keyless work to get it to work properly. I then realized that the movement stopped working. Upon further inspection I found out that the escape wheel isn't engaged with the second wheel. The escape wheel is also very loose on the top part close to the bridge. Do I have to replace my escape wheel and what seems to be the problem? Is there a pin at the top which was sheared off? Thanks. 

VID_20180304_231841.mp4

[khunter]

Yes the pivot is broken off.

[BUSAKAZ]

Yes the pivot is broken off.

Dito


Sent from my iPhone using Tapatalk

[jdm]

3 hours ago, SeeJianShin said:

I recently purchased a sellita sw-200-1 movement and it was working fine.

Good luck with the repair. FYI we've a section where most members like to introduce themselves.

[SeeJianShin]

17 hours ago, khunter said:

Yes the pivot is broken off.

Alright.....

Thanks about that. Gotta find an escape wheel now.

[SeeJianShin]

14 hours ago, jdm said:

Good luck with the repair. FYI we've a section where most members like to introduce themselves.

Thanks! I'll go there soon but I'm not that much of a watch repair enthusiast myself. This is just a one time project. If I face problems or I have more experience in the future I'll do a nice lengthy introduction.