Jump to content
  • Recently Browsing

  • Topics

  • Posts

    • Welcome to the forum  
    • I cleaned the hole thing, and oiled it using 9010 and hp1300. On the exit stone of the first pallet I put a drop of 9010, I've seen others using it although I now it's not the best there. I didn't oiled the second pallet. I have no photos of the timegrapher screen, and as I do not have a permanent desk I have uninstaled it. I'll take some photos next time I check the watch. But the data I gave is about what you can see there, the lines are very clean and nice in all positions except crown down, where they are quite messy. Lift angle was established at 53.0. I do not think there is any other relevant information you can see on the screen, is there?
    • Does your timing machine show a graphical display you can show us? Besides swapping escapement components what other servicing have you done to this watch? Plus what sort of lubrication are you using especially on the escapement components.
    • BLEURGH! Don't know how that ever became a "delicacy" in the Philippines!
    • We need a clear picture looking in sideways at the hairspring and balance wheel in the watch. Then yes technically her out a center but it's minimal it shouldn't be the cause of amplitude problems. They hairspring not flat would be a cause of problems especially when it's touching something. Can we get timing machine results? And that includes the graphical display with the numbers.    
×
×
  • Create New...