Jump to content
  • Similar Content

    • By George19
      Hello,
      Now going to tackle my second Seiko repair after fixing a displaced 7S26-C rotor/bearing (posted in another thread). I'm still a newbie at all of this, but learning by watching, reading and doing. I'm really enjoying the work, I wonder why I did not learn this art years ago.
      I was given a Seiko 7009-3040 automatic for free. I took a look at it and saw that is had a bent second hand. Closer inspection showed the little [ S ] emblem has been disconnected from the face and is rolling around between the dial and the face (show here resting next to the 4 o’clock position. It was actually in the day/date window hiding at first. After a bit of tapping it came out.
      I was thinking it might be not too hard to fix?  Separate the  movement from the case of course. Then glue the [ S ] emblem back in place on the dial using a very small amount of super glue. I can see two small holes for mounting. Bend the second hand back to straight.
      So the real questions are
      is super glue OK for this application, I would assume to let the dial stay out of the case for a day or two to protect the rest from 'glue fogging'. looking a the second hand, I'm almost sure it just might break if I try to straiten it? had anyone else seen this happen, the emblem falling off and fouling the hands? Thank you very much in advance.
      Cheers

    • By Mark
      In this video I am correcting a few mistakes I made in the Seiko 7S26 service and lubrication series of videos.
    • By Mark
      In this video I am correcting a few mistakes I made in the Seiko 7S26 service and lubrication series of videos.

      View full YouTube video
  • Recently Browsing

    No registered users viewing this page.

  • Topics

  • Posts

    • are we talking about round wylers?  the special crystols are hard to find. there were several colors.     vin
    • I'm going to have to do something. One decent desk lamp and bulbs high up in the ceiling are not enough for me.
    • You are most welcome.
    • Thats  a poser,  what I had fitted to the bench at on time was a four in line which used halogen bulbs the same thing uses LEDs now and fitting that up with some 2by1 and made colapsible so that it folds up. the multiple light array should go some way to removing the shadows as the lights strike at different angles,  if it has a decent base a G clamp will fix it to the table/bench, food for  thought.
    • Yes, something like that might do the job. In many ways similar to the goose neck lamp I’m looking at. If only I knew what I need. The light in the picture I posted is very good (not the small one), it’s the fact that it is slightly in front of me hence the shadows. I can move it right above what I’m working on, but again, there will be shadows elsewhere because my hand and head will get in the way. I’m starting to think that a floor lamp next or close to me will be the best solution, casting the light from opposite direction. A head torch would be perfect but I don’t want to sit there with it on for hours. When I look at Mark’s oiling videos (jewels) it’s so clear, yes it’s a lot more magnified than my 12x loupe but there are no dark areas.
×
×
  • Create New...