Jump to content

Recommended Posts

  • Replies 227
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Popular Posts

I've been using and abusing ultrasonic cleaners for more than 30 years. I've also repaired many units for friends. I've encountered brands like Elma and L&R Quantrex, and unbranded ones like Chine

Like almost everything else in this group we've discussed this before. So I have a link all kinds of ideas and I swiped a picture out of the link to post here. I'm using commercial watch cleaning

Really? Maybe during the war it was the only thing available. Below a page from an early 1900 watchemaking book, benzine is the same product is still best fo degreasing, and post-ammonia rinsing. You

Posted Images

On 6/10/2021 at 3:02 PM, jdm said:

Really? Maybe during the war it was the only thing available. Below a page from an early 1900 watchemaking book, benzine is the same product is still best fo degreasing, and post-ammonia rinsing. You will find the same guidance in the Bulova school text, etc. 

benzine.png.9fd24894427c8158cac40cfa0e43904e.png

So benzine, equals lighter fluid:)

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.




  • Recently Browsing

    No registered users viewing this page.

  • Topics

  • Posts

    • Yes it can;  perhaps impulse jewel can't enter the fork horn, if the shock has  knocked a pallet jewel out of alighnment or bent a pivot. Remove the two black screws then the automatic device, loosen the cock screw by couple turns, raise the bridge just enough to pass the impulse jewel over the fork so to get impulse jewel inside the horn, tighten cock screw. It will run, however , might get stuck again if pallet jewels have got misaligned or a pivot has got bent.
    • A little uninspiring.  It does run though...kinda.
    • I decided to find a knew winding pinion for my Vulcain.  I see some wear on the one I have.  I have the spec sheet on the Vulcain 120 and identified the part as #1246.  I searched around and found scotchwatch.com had one.  $45.  I really want it, so I bought it.  Meanwhile, I continued my search and found a part with a different part number (410) on Northern Watch & Clock Supplies in the UK.  It was just a couple of pounds, so I bought it. Later I looked at the invoice from scotchwatch.com and see that the part I bought is 1246 (410), so I think the part has two numbers.  Well, we will see when they arrive.  On part cost 20x the other one.  I am not complaining...as I am glad that someone takes the effort to maintain an inventory for budding watchmakers like myself.  I just think it is interesting. Learning new things every day.
    • Thank you for your introduction and welcome to this friendly forum. A nice looking watch you are wearing. 
    • The hairspring is partially blocked from view by the autowinder but looks to be ok.  The balance swings with a puff in one direction but not the other.  Could it be the position for the impulse jewel and fork?
×
×
  • Create New...