Jump to content

Existing user? Sign In
Sign In

Remember me Not recommended on shared computers

Forgot your password?
Sign Up

Chat About Watches & The Industry Here

Landeron 48

By Martgeh
April 25, 2021 in Chat About Watches & The Industry Here

Share

Recommended Posts

New Member

Martgeh

Posted April 25, 2021

- Share

Posted April 25, 2021

Hello has anyone tried putting a landeron 48 movement in a seagull st19 case thanks

martyn

Quote

Link to comment

Share on other sites

Distinguished Member

Michael1962

Posted April 30, 2021

- Share

Posted April 30, 2021

Welcome to the forum Martyn.

I haven't as I am fairly new to all of this, but other guys will be along that may be able to assist.

As this is the forum for Introductions, you might get more help if you ask this question in the Watch Repairs area.

Quote

Link to comment

Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest

Reply to this topic...

× Pasted as rich text. Restore formatting

Only 75 emoji are allowed.

× Your link has been automatically embedded. Display as a link instead

× Your previous content has been restored. Clear editor

× You cannot paste images directly. Upload or insert images from URL.

×

Share

Go to topic listing

Recently Browsing
- No registered users viewing this page.
Topics
- 57
  
  Movement holder made with 3D printer
  
  LittleWatchShop · Started April 11, 2021
- 1
  
  Battery clamp screw needed for Tag Heuer CT1111-0
  
  Kmacaaa · Started 3 hours ago
- 1
  
  Introduction
  
  Kmacaaa · Started 3 hours ago
- 22
  
  Is this pallet fork over-locking?
  
  margolisd · Started September 16, 2020
- 1
  
  Vintage pocket watches from e-bay (winding stems needed)
  
  Mallard · Started 2 hours ago
Posts
- Movement holder made with 3D printer
  
  By LittleWatchShop · Posted 10 minutes ago
- Battery clamp screw needed for Tag Heuer CT1111-0
  
  By RichardHarris123 · Posted 47 minutes ago
  
  You can buy an assortment from cousins etc or ebay.
- Introduction
  
  By RichardHarris123 · Posted 48 minutes ago
  
  Hello and welcome from Leeds, England.
- Is this pallet fork over-locking?
  
  By Malocchio · Posted 1 hour ago
  
  Thanks for the help guys! VWatchie I already found your thread but I'll check it again. Nice to know about acetone, I still have to get the shellac off since I made a little mess. I adjusted the jewel, put new shellac (the so called soldering technique, pallet tool too hot this time so the shellac "wire" melted in air before getting in contact with jewels or fork) rinsed the pallet fork and put it back dry. Amplitude is now in the 240-250 range that I expected in the first place. I guess there's enough oil in the escape wheel teeth already but I'll check that later. The mainspring was pretty beaten so a new one would probably boost the amplitude even further. Nice to learn new things. Now I have another thing to look for while disassembling. I wonder if the watch left the factory that way.
- Movement holder made with 3D printer
  
  By Waggy · Posted 1 hour ago
  
  Would be interesting to see it 🙂

×

×

Create New...