Jump to content

Ever see a balance like this?

KarlvonKoln
 Share

Recommended Posts

KarlvonKoln Distinguished Member

KarlvonKoln

Posted
Posted

I was just drinking coffee this morning and poking about on Ebay...when I happened upon this movement.  The seller didn't seem to know much.  I can tell it's a Swiss bar, key wind & set, no idea of the maker.  But I have never seen a balance wheel like this.  Ever.  Has anyone on this forum seen one like this?  I'm curious to find out more.  I wonder if there is a mechanical explanation to this design, or if it's done purely for aesthetics.  It's fascinating either way.  And it looks like the largest diameter they could cram in there too, which would have several advantages.

s-l1600.jpg

  • Like 1
Link to comment
Share on other sites
oldhippy Distinguished Member

oldhippy

Posted
Posted

There is always something different that comes into the workshop with horology. I first started as a watchmaker then went into clocks for around 30 years.  Due to the internet I see new things nearly every day. You never stop learning.

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Waggy
      Pocket watch escape wh

      By Waggy · Posted

      This is a very valid point and a subtlety that I was unaware of until fairly recently, learning all the time, the video below explains this point well:  
    • HectorLooi
      Blew it with a coil

      By HectorLooi · Posted

      You don't have to use his special tester. Any good multimeter would work.
    • nevenbekriev
      Pocket watch escape wh

      By nevenbekriev · Posted

      Yes, it looks like GT Revue 30. Doctor, You can not replace escape wheel by the dimensions You listed. One needs to know much more things like number of leaves of the pinion and it's diameter, the position in high of the table and the pinion, the hight between the pivots, the exact pivots diameter... And then, even if suitable wheel is found, one will need to know how to adjust the pallets position correctly. Restoring antique movements is something different than replacing parts. In older movements parts are not interchangeable, this means spare parts do not exist. Here the case is different, but still escapement adjustment will be needed if a wheel from a donor is found. So may be it will be easier to restore the donor for You...Restoring antique movements usually means making of the parts needed and this requires knowlage and working on lathes skill. In this case repivoting of the wheel is the natural solution, but there is a long way that one must walk untill getting ready for such work.
    • Waggy
      How to store one dip

      By Waggy · Posted

      I was looking at Essence of Renata, a chemical used a lot for cleaning hairsprings: "Specially prepared solution for degreasing watch and instrument components. Indispensable for degreasing hairsprings." Looking at the MSDS you can see this is just pure n-Heptane, so could be an option for those who don't want to use the chlorocarbons or hexane?     HF6013 - Horological Essence COSHH Safety Data Sheet Horological Essence_0.pdf
    • Kkramme
      Self introduction

      By Kkramme · Posted

      Great!! 👍 
×
×
  • Create New...