Jump to content
  • 0

Rolex GMT Master Service Sheet


Question

5 answers to this question

Recommended Posts

  • 0

Rolex is extremely paranoid company. Technical information is extremely hard to get there are a few parts lists out there but it's only for the older stuff. for the most part there's almost 0 technical guides out in the wild as a PDF. this leaves the only source that I know of to get anything that resembles a modern service guide is eBay. Like the manual below really beautiful in color.

 

https://www.ebay.com/itm/ROLEX-CALIBER-3186-MOVEMENT-TECHNICAL-BULLETIN-SERVICE-INFO-MANUAL-BOOK-ENG/302150612993?hash=item4659947801:g:SbEAAOSwiONYOznJ

 

 

Link to post
Share on other sites
  • 0
56 minutes ago, Peterburke340 said:

Rolex-3135-tech
slandis [ AWCI-DOTT ]


Sent from my iPhone using Tapatalk

SOrry Peterburke340, this did not come through if you wanted to attach a document.

Link to post
Share on other sites
  • 0

you can find your parts lists here

https://www.cousinsuk.com/document/search?SearchString=rolex

8 hours ago, Peterburke340 said:

Rolex-3135-tech
slandis [ AWCI-DOTT ]

I've attached the PDF that's missing from up above. I think this is about the only service guide available the problem is if you look at the table of contents it's supposed to 40 pages long the reality is it's 20 pages. So this means if I place you get a service guide is to physically by one nobody is bothering to scan them into PDFs at least that I'm not aware of anywhere.

Rolex-3135-tech.pdf

Link to post
Share on other sites


  • Recently Browsing

    No registered users viewing this page.

  • Topics

  • Posts

    • So what you guys are saying is I need to hire a sound and boom guy? 😄
    • Actually all it would take is something to slip over the installation anvil to make it a concave support and it could then be used for both installation and removal.
    • 20X    is strong enough.  will you show picture of hairspring and end stones. there usually are two little screws that hold end stone plate down,  just drop the cock in coca-cola let soak for 20 to 40  hrs, you would need to dress a screwdriver blade for perfect fit in slot of the two little screws  then lay the cock on a bench, press screw driver balde with a little force into the slot of screws and unscrew em, they opens with incredable ease when soaked in coke. Check, clean, peg if you can, lube and reinstall end stones, let us see a close up of jewels. End shake is your free axial play on balance staff, so use an oiler to lift balance wheel, you should see an axial free play, ideally .02mm is good. In case you see no end shake, you can shim up or gauge the cock to create some end shake. Check if impulse jewel is damaged or loose and it has to be way out of adjustmemt not to continue running. Keep us posted please.                
    • This is my China made case tube extractor. The pin presses the case against a teflon support. In compression mode, it's less likely to distort the case.  Is it possible to configure your tool to compress from the inside of the case?
    • Afternoon all, I’ve just ordered a crystal press and a replacement crystal for a friends watch, the crystal was all cracked and fell to pieces when pressed from the inside. The gasket is still intact and seated in place and I plan to re-use it. However, am I best to leave the gasket in-situ and press the new crystal in to it, or do I remove the gasket and loosely seat in on the bezel along with the crystal then press them both in to place?. Thanks
×
×
  • Create New...