Jump to content

Should I give up on this pocket watch

Daniel123
 Share

Recommended Posts

anilv Distinguished Member

anilv

Posted
Posted

Sell it on to someone who can.

I can't make a balance shaft , its too much effort  so I'm pretty content to just replace them if I can source parts. Otherwise it moves on.

Anilv

Link to comment
Share on other sites
watchweasol Distinguished Member

watchweasol

Posted
Posted

Hi   the problem with old english lever and fusee watches was the manner of their manufacture, Plates made by one person the wheels cut by another and all assembled by the "maker". There are subtle differences in a lot of them that require broken parts to be repaired or re made individualy or if you are lucky finding a donor watch, best advice is if you neither have the tooling to make a staff is keep it for spare or sell it on for spares

Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Jon
      What are these Seitz B-Jewels?

      By Jon · Posted

      I picked up a similar amount of these jewels some years ago in a watch and clock fair. Every now and then they come in handy. This week I've got a rubbed in bombe jewel in the balance cock that is cracked and needs replacing. Very handy to have a vintage assortment of these type of jewels!
    • Stirky
      Diagram for 6497 motion works

      By Stirky · Posted

      Thanks Jon.
    • Jon
      Diagram for 6497 motion works

      By Jon · Posted

      Great diagram with the teeth and pinion count. Simple way to reduce the speed of the hour wheel by the 12:1 minute wheel. Genius and yet so simple. Always good to reinforce the principal by what you have done in your drawing. Keep doing that. I had a drawing on my wall for years showing me this which is very similar to the drawing you have done. Here's a formula to work out the beats per hour of a watch movement. The movement's BPH is dictated by the wheel teeth and pinion count and the hairspring being vibrated to the correct BPH by finding the pinning up point on the hairspring using a vibrating tool.  The reason in the formula there is X2 on the top line is because there are two pallet stones.
    • DDean
      Incabloc Lyre Spring & Low Earth Orbit

      By DDean · Posted

      So I just wanted to say "thank you" again.  The angle is the key bit it seems and yes, it did basically just fall, or float, back into position when I got it lined up just right. I had meant to add that now that I see how it goes in, I totally see how it came out in the first place, and that whomever cloned the original movement didn't pay much attention to the fine details around the setting or how it interfaces with the balance cock or the "rings" on the regulator and/or stud carrier arms.
    • transporter
      Commando special

      By transporter · Posted

      Well I’ve never seen the make before and cannot find any info, I haven’t got it just yet it’s been left to me among a 1970’s sea master and a mid size yeoman. But if anyone has any information on this one please feel free to enlighten me, many thanks 
×
×
  • Create New...