Jump to content
  • 0

Rolex Day Date Service Manual


Question

Hi,

Rolex Day Date landed on my bench and I can't find any service sheets online.
Would someone be able to help please?

The calibre says 3035

Thanks!

Link to post
Share on other sites

4 answers to this question

Recommended Posts

  • 0

actually the cal must be 3055 as it is an old day-date with only date rapid change.

still looking for service advice and ideally manual link.

Thanks!

Link to post
Share on other sites


  • Recently Browsing

    No registered users viewing this page.

  • Topics

  • Posts

    • Hello all, Very, very new to this watch repair lark but reading and Youtubing my way along. No doubt you will see some exceedingly stupid questions coming along from me shortly. Thanks.
    • Welcome back my friend.
    • Hi all, I have had to install several times second hand on my omegas (10xx) that were a pain due to their soft spring. I have not an omega holder, so I made my own "tool" from a piece of copper wire with the end filed flat. I removed the auto weight whose axle lays just below seconds pinion, and dropped the wire to just lay on the seconds pinion. Then marked the wire where it exits from the rotor hole and bent it from the mark to make an "L" with the shaft measuring just the length from the rotor base to the seconds pinion. Let it go through the rotor hole and check that shaft goes all the way down, to ensure no pressure will damage the seconds pinion or axle.   Simply lay it on the movement, support with a piece of tape and lay the movement on a flat surface. with the new "L" tool lying on the bench. The seconds axle will remain in place while installing the hand. Not a high tech solution, but it served me. I hope it helps you, taking care to not miss axle length, better short than long Sorry, but I have not better photos, I did new just to give you an idea. The last two are the actual size and position on my watch Regards
    • Just a brief Hello, I have not been active on the forum for some time but without going into detail there have been a few health setbacks and deterioration of sight has not helped. Ironically I have just recently been given an excellent watch makers lathe and am enjoying my practise with it.  I am still tinkering but it takes much longer than it used to. I have an ancestors company verge fusee pocket watch in pieces at the moment, it is signed but as with these items probably not much of his own work gone into it.  I will be working on it from time to time but parts may be an issue. Also an Omega bumper is in pieces, cleaned and ready to work on.  So not quite written off yet. If anyone is interested, John Robey has published a PDF on Academia about Sam Harlow, one of my Ancestors from the line of Ashbourne Clock and Watchmakers,a Long Case Clockmaker.  Its quite interesting, obviously to me, but others may be interested, I may have a word with him and get permission to put it on the Forum for folks. Anyway, hello to everyone for now and I will be popping back again from time to time. Cheers, Vic  
    • What Joe explains is good practice as it tests the balance and allows good observation of the same   and not having to worry about the fork engagement as the balance is free swinging.
×
×
  • Create New...