Jump to content

Heuer Solunar bezel and caseback needed


Recommended Posts

  • 3 weeks later...

I suppose that you should contact the official service center about availability of these parts, I think it's unlikely, but one never knows. If parts are available you will have to send the watch in for repair and service.

  • Like 1
Link to comment
Share on other sites

Considering that 

20 minutes ago, Crabchilli said:

Thanks so much, Heuer could not answer and told me „send in the watch and then we see...“ but service is min. 1300€... sure!

You're very welcome. Considering that this is a watch with asking prices starting at EUR 7,800, it would make sense to have it repaired even if at an high cost. I suppose you can send it in on the basis that you will pay even just an inspection fees only if the manufacturer can provide the parts.

 

Link to comment
Share on other sites

Hi JDM,

yes, they are quite expensive, but I first try my luck with social media and the many collectors and freaks out there... like me... I bought a very similar Solunar in very bad shape with no bezel, then Henrik (a Skipper expert) sold me a spare ring, I had it serviced and did the finishing myself! See image how it looks now!!

So I will try my luck again...

Niko

IMG_5511.HEIC

Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • I picked up a similar amount of these jewels some years ago in a watch and clock fair. Every now and then they come in handy. This week I've got a rubbed in bombe jewel in the balance cock that is cracked and needs replacing. Very handy to have a vintage assortment of these type of jewels!
    • Great diagram with the teeth and pinion count. Simple way to reduce the speed of the hour wheel by the 12:1 minute wheel. Genius and yet so simple. Always good to reinforce the principal by what you have done in your drawing. Keep doing that. I had a drawing on my wall for years showing me this which is very similar to the drawing you have done. Here's a formula to work out the beats per hour of a watch movement. The movement's BPH is dictated by the wheel teeth and pinion count and the hairspring being vibrated to the correct BPH by finding the pinning up point on the hairspring using a vibrating tool.  The reason in the formula there is X2 on the top line is because there are two pallet stones.
    • So I just wanted to say "thank you" again.  The angle is the key bit it seems and yes, it did basically just fall, or float, back into position when I got it lined up just right. I had meant to add that now that I see how it goes in, I totally see how it came out in the first place, and that whomever cloned the original movement didn't pay much attention to the fine details around the setting or how it interfaces with the balance cock or the "rings" on the regulator and/or stud carrier arms.
    • Well I’ve never seen the make before and cannot find any info, I haven’t got it just yet it’s been left to me among a 1970’s sea master and a mid size yeoman. But if anyone has any information on this one please feel free to enlighten me, many thanks 
×
×
  • Create New...