Jump to content
  • Similar Content

    • By east3rn
      Hello. 
      I am about to work on a Omega ladies automatic watch.
      I found out that the axis of the rotor is out of place and shakes up and down.
      What could be done in this situation?
      Thanks!

    • By DouglasSkinner
      I have an old Waltham pocket watch movement which is missing the impulse pin (roller jewel).  I have a limited number of actual jewels and since this is just a practice movement I thought I'd try to make one out of brass.  I've seen this several times in old pieces--usually a very sloppy job.  So I got some brass stock of the same diameter as the "D" in the roller table, filed it and burnished it to a high gloss.  Then I took a small, very fine diamond file and filed it half flat to form the "D"  I then polished the face using progressively finer sandpaper on a steel block.  This works fine--so far!  Problem is separation of the piece from the stock.  Again I used a small cutting file to do this but it doesn't leave the end very pretty.  So what I've done so far is to fit the good end into the roller table.  I then plan to shellac it in place and see if I can very carefully adjust the length and clean up the end.  Has anyone done this before?  Any suggestions as to how best to do it?  
    • By arkobugg
      Cheers mates!!
      Had to get new winding stem to an Omega cal. 342 , beacuse not original crown.
      Got an replacement from Ronda, but does not fit.
      Tried to fit the stem yesterday, but Im not able to get in in right in the movment.   The original just go right in every time, but the new Ronda stem will not go properly in.   Are there anyone that have some ide why this not fit?   Can the notch in the stem where I have put red arrow have somthing todo with this??   Its slightly smaller on the Ronda stem...  se photo  

    • By arkobugg
      Cheers Mates!
       
      Working on a Omega Cal. 613, have done service, and watch performs well on the time-grapher, but when put dial and hand on, I can see that the
       
       
       
       
  • Recently Browsing

    No registered users viewing this page.

  • Topics

  • Posts

    • Suggest that you post in the correct forum which is "watch repair help" or perhaps "chat about watches", because not everyone reads all sections. You can also ask moderator to move you post.
    • There is no other way. Note well, it is a 600m waterproof watch, these are normally built with as single piece cases, quartz or mechanical.
    • Good approach.  I have made a habbit of checking set mech with just the mainplate and stem, fixing faults, rinse and start assembly with stem attached.  I feel more direct control over/ much improved stem installation and results. Good percentage of postings for help are about stem issues, most of which will surprisingly be eliminated if we start assembly with " stem issues solved" approach.  
    • Thanks, and yes, that could very well be the problem! The design definitely seems to leave no room for imperfections! However, I'm happy to say that I just came up with a solution. I'm not a technical guy so I really, truly surprised myself (än är inte undrens tid förbi ). I realized that the case was big enough to insert the movement into the case with the stem attached to the movement, crown unscrewed of course, and then hold the stem with pliers inside the case while screwing back the crown from the outside of the case.
    • Somehow, I missed this one. I have not gone through all the posts. The s/spring hangs from the small bracket behind the movement, red circle; the pendulum and its rod are attached to the s/spring. The crutch fits into a slot in the pendulum. The s/spring and pendulum fitting is similar to a Vienna wall clock, the proper ones not the cheap German type.
×
×
  • Create New...