Hello, I could not fint any answer to this on any other thread.
Im using Isopropyl alcohol for the last step of hand cleaning movements. However i can not find a good way to throw used liquid away. How do you do it, I know that the liquid will turn into gas eventually however since i fill a small jar there is always going to come times when i need to throw it away. Where do i throw it?
How do you do it?
Thanks in advance, Jakob
Hi everyone. I'm brand new to watch repair, but I'm starting to really get into it as a hobby. I'm a 30something American living in Taiwan. Right now I'm really interested in old Walthams from the 1920s and 1930s, and old Hamiltons from the 40s and 50s. I have a few real-life friends who do repairs for one of the big Swiss companies, so they're mostly to blame for me getting into this. I normally don't join forums, but talking to experienced people seems like the best way for me to solve some essential challenges, and hopefully to learn.
Strangely, I'm was able to find out any information for the above and have not been able to get on NAWCC message board for whole of this week.
Need the information to look at possible options for hands.
Hi to you all,
I was wondering, if you use a regular ultrasonic instead of a watch cleaning machine. How would you rinse your parts? And how many times? In which solutions?
I always cleaned my parts in the ultra sonic with a solution and rinsed the parts in benzine( that's the way an old watchmaker learned me) but i've found out that very often this does not give me the results i was hoping for. Can I perhaps get little jars with a rinse solution and run those in the ultra sonic?
What the problem here is for your question is Mark's video is confusing. Normally when you do a balance staff you would statically poise first then sometimes dynamically poise. If your dynamic poising you use eight pendant positions usually. So in his video he comments for this particular watch he is dynamic poising.
Then adjusting to positions is an interesting term or as your question is which positions should you worry about timekeeping in? Basically what you're doing by timing the watch on the timing machine in a variety of positions is your verifying the watch does keep time in those positions.
So for pocket watches dial up and crown up are the most common.
For wristwatches I'm attaching what Omega recommends for their watches
check each as old hippy said but end shakes on a 3rd wheel allow a lot more play than lets say a balance or escape. you can get away with too much end shake and not loose much amplitude, too little will def not work though and will def result in a very low amp and or stop the movement. train wheels being loose is always better than too tight in my opinion
its farfo.com dont put the www. or just google farfo vintage watches ridgewood nj. archer is a memeber on teh Watchuseek forums and is very good esp when it comes to high end watches like omega. he is a certified omega repairer, not many of those around. he uses the same equipment they uses at the omega facilities. 100,000s worth of equipment