Help with Hamilton Multi-Touch back removal

[Gpsluvr]

Does the back unscrew by placing a typical 3 pin wrench into the rounded slots on the back? For the life of me I can’t get the back to turn at all. I know they allow water into the inside in order for the barometric pressure sensor to work, and I figure that it can cause corrosion between the back and the case threads. Any suggestions? Thanks, Steve

 

 

 

 

 

 

Sent from my iPad using Tapatalk Pro

[jdm]

Water Resistant 30 meters, I think that is a snap back case. See if there is slot to start prying in between lugs, otherwise see if you can (slowly and carefully) lever on top of the arches.

Edited May 19, 2019 by jdm

[Gpsluvr]

You were right! I stuck a single edge razor into it at the 9 o’clock position and it popped right off. It uses one of those rd nylon rings for the seal. Thanks. Steve





Sent from my iPad using Tapatalk Pro