Jump to content

Croton Sterling Silver Pocket watch

jameswarner1011
 Share

Recommended Posts

Nucejoe Distinguished Member

Nucejoe

Posted
Posted

Hi J, Sorry for my late response. For some reason I had thought I replied, old age.

My view is one of a collector.  The movement looks in mint condition, seems to me dial has had better complexion in youth. 

I would not sell.       :geek:

Best wishes.

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • VanDan
      Bench mat

      By VanDan · Posted

      I'm new to the craft, but I have been using a neoprene mat (think a giant mousepad). It can get a bit dirty but nothing slides or bounces off it, it has stopped a few screws from bouncing off my desk into the abyss.
    • oldhippy
      Where to buy a sunburst wire wheel?

      By oldhippy · Posted

      Have you looked here. https://moleroda.com/radial-wheels-for-cleaning-and-polishing/
    • oldhippy
      Hello fellow watch enthusiasts!

      By oldhippy · Posted

      Thank you for your introduction and welcome to this friendly forum. We all look forward to your contributions and continued involvement. 
    • xyzzy
      Seiko 7t32-7f70 Service/Repair

      By xyzzy · Posted

      The problem sounds very much like what might happen when failing to do the reset procedure. The stopwatch not working could be a few things.  There are two different motors, one for the center sweep seconds and one of the minute counter.  Damaging a coil is the most likely thing to do wrong when changing the battery, but that would likely just take out one of the two.  So "start" it wait and see if the minute counter doesn't tick over.  If that ticks, and you've done the reset procedure, it's probably damage to the sweep second coil. If neither works, then it could be the button contact is damaged.  It's a tiny bit of copper trace on the PCB that curls around the edge to make a circuit and it can break off.  There's a way to trigger the buttons from the small pads on the back of the movement, as well as check them with a multimeter, if you are familiar with one. But give this a try, pull the crown out to the second position and hold down button "B" (10 o'clock) for a few seconds.  This is suppose to spin the minute counter to let you reset it to 0.  If it doesn't move and (I assume) button 'A' (2 o'clock) doesn't start the chronograph, then either both buttons have failed at the same time or there is something else wrong. A leaking battery can take out the traces on the circuit board, and this can take out the motors and/or buttons, but you didn't say anything about it and it should be obvious if it leaked enough to do that.  
    • Endeavor
      Seiko 6139A & 6139B technical service manual WARNING !!

      By Endeavor · Posted

      Perhaps not where you live, but here in DK, you get by the taxman financially quartered if you order from outside the EUSR. These center wheel weren't that expensive 5 - 7 years ago, around $45-$50. I guess stock is drying up and these days we have to pay with worthless confetti money.
×
×
  • Create New...