Jump to content

A toolbox


Squiffything

Recommended Posts

Thanks guys. Christmas I think it’ll take longer than that! 

My first project is in hand, repairing a broken pivot. I’ll show how I’ve gotten on once I’ve finished.

Not too sure on the belts, they look a little used so with the new motors they will be replaced. I have had a fun day playing :)

Link to comment
Share on other sites

7 hours ago, JimmyD said:

If this is the 1st pivot you are doing maybe get an old pivot or just a bit of round steel and have a practise before you do the one for the clock.

That’s the plan Jimmy. I’ve had a go at turning down a thin bar drilling into the end and also thinning down a piece of pivot wire and shaping it. Working this small is a challenge. Getting the centre point is very tricky but the U3 is pretty tight. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...